[PATCHv1] arm: armada: Add .dts file for Netgear ReadyNAS 102
jason at lakedaemon.net
Fri Jul 5 10:29:51 EDT 2013
On Thu, Jul 04, 2013 at 11:16:46PM +0200, Arnaud Ebalard wrote:
> All hardware parts of the (Armada 370 based) NETGEAR ReadyNAS 102 are
> supported by mainline kernel (USB 3.0 rear ports, USB 2.0 front port,
> Gigabit controller and PHY, serial port, leds, buttons, SATA ports,
> G762 fan controller) except for:
> - the Intersil ISL12057 I2C RTC Chip,
> - the Armada NAND controller.
> Support for both of those is currently work in progress and does not
> prevent boot.
> Signed-off-by: Arnaud Ebalard <arno at natisbad.org>
> Hi Jason and Andrew,
> As requested
> - this version is tested against current head of linus tree (+ I2C
> fixes for a race condition; for details, see message #94 of
> - nand layout entry and ISL12057 entry have been removed until support
> is available in mainline kernel for eahc of those
> - clock, gpio led and keys have been made siblings of soc, memory and
> chosen (reported by Sebastian).
> Is it still acceptable for current merge window or am I too late?
Unfortunately, it's too late for v3.11. The arm-soc cutoff is typically
-rc6 or so. Which usually means we need to see it on lakml by -rc5.
So, you're ahead of schedule for v3.12 :-P
However, with any luck, maybe Ezequiel will have something ready for the
nand driver in time as well...
More information about the linux-arm-kernel