[PATCH] ARM: at91/DT: at91sam9x5ek: fix USB host property to enable port C

[Jean-Christophe PLAGNIOL-VILLARD]

On 13:00 Wed 03 Jul     , Nicolas Ferre wrote:
> Device Tree "num-ports" property of USB host node has to be
> set to maximum number of ports available.
> The possibility to activate a particular port is done by specifying the proper
> gpio configuration for its vbus.
> 
> This patch fixes the USB host node by configuring the 3 ports available on the
> product and letting "port A" available for USB gadget usage.
> 
> Reported-by: Rodolfo Giometti <giometti at enneenne.com>
> Signed-off-by: Nicolas Ferre <nicolas.ferre at atmel.com>
> Cc: Bo Shen <voice.shen at atmel.com>
Acked-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>

> ---
>  arch/arm/boot/dts/at91sam9x5ek.dtsi | 5 +++--
>  1 file changed, 3 insertions(+), 2 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/at91sam9x5ek.dtsi b/arch/arm/boot/dts/at91sam9x5ek.dtsi
> index b753855..49e3c45 100644
> --- a/arch/arm/boot/dts/at91sam9x5ek.dtsi
> +++ b/arch/arm/boot/dts/at91sam9x5ek.dtsi
> @@ -94,8 +94,9 @@
>  
>  		usb0: ohci at 00600000 {
>  			status = "okay";
> -			num-ports = <2>;
> -			atmel,vbus-gpio = <&pioD 19 GPIO_ACTIVE_LOW
> +			num-ports = <3>;
> +			atmel,vbus-gpio = <0 /* &pioD 18 GPIO_ACTIVE_LOW *//* Activate to have access to port A */
on 2 line would have been more clear


Best Regards,
J.
> +					   &pioD 19 GPIO_ACTIVE_LOW
>  					   &pioD 20 GPIO_ACTIVE_LOW
>  					  >;
>  		};
> -- 
> 1.8.2.2
>