[PATCH 09/10] gpio: pxa: move gpio properties into child node

Igor Grinberg grinberg at compulab.co.il
Mon Jan 28 06:27:35 EST 2013


On 01/23/13 10:25, Haojian Zhuang wrote:
> Move gpio properties into child node. So pinctrl driver could binds to
> each gpio chip with gpio range.
> 
> Signed-off-by: Haojian Zhuang <haojian.zhuang at linaro.org>
> ---
>  drivers/gpio/gpio-pxa.c |   33 ++++++++-------------------------
>  1 file changed, 8 insertions(+), 25 deletions(-)
> 
> diff --git a/drivers/gpio/gpio-pxa.c b/drivers/gpio/gpio-pxa.c
> index 21cf8fd..528f742 100644
> --- a/drivers/gpio/gpio-pxa.c
> +++ b/drivers/gpio/gpio-pxa.c
> @@ -63,10 +63,6 @@
>  
>  int pxa_last_gpio;
>  
> -#ifdef CONFIG_OF
> -static struct device_node *pxa_gpio_of_node;
> -#endif
> -
>  struct pxa_gpio_chip {
>  	struct gpio_chip chip;
>  	void __iomem	*regbase;
> @@ -404,9 +400,9 @@ static const struct irq_domain_ops pxa_irq_domain_ops = {
>  
>  static int pxa_gpio_probe_dt(struct platform_device *pdev)
>  {
> -	int ret, nr_banks;
> +	int ret;
>  	struct pxa_gpio_platform_data *pdata;
> -	struct device_node *prev, *next, *np = pdev->dev.of_node;
> +	struct device_node *np = pdev->dev.of_node;
>  	const struct of_device_id *of_id =
>  				of_match_device(pxa_gpio_dt_ids, &pdev->dev);
>  
> @@ -432,25 +428,7 @@ static int pxa_gpio_probe_dt(struct platform_device *pdev)
>  	/* set the platform data */
>  	pdev->dev.platform_data = pdata;
>  
> -	next = of_get_next_child(np, NULL);
> -	prev = next;
> -	if (!next) {
> -		dev_err(&pdev->dev, "Failed to find child gpio node\n");
> -		ret = -EINVAL;
> -		goto err;
> -	}
> -	for (nr_banks = 1; ; nr_banks++) {
> -		next = of_get_next_child(np, prev);
> -		if (!next)
> -			break;
> -		prev = next;
> -	}
> -	of_node_put(prev);
> -
>  	return 0;
> -err:
> -	iounmap(gpio_reg_base);
> -	return ret;
>  }
>  #else
>  #define pxa_gpio_probe_dt(pdev)		(-1)
> @@ -460,6 +438,7 @@ static int pxa_init_gpio_chip(struct platform_device *pdev, int gpio_end,
>  			      int (*set_wake)(unsigned int, unsigned int))
>  {
>  	int i, gpio, nbanks = gpio_to_bank(gpio_end) + 1;
> +	struct device_node *next, *np = pdev->dev.of_node;

The above introduces:
drivers/gpio/gpio-pxa.c:453: warning: unused variable 'np'
drivers/gpio/gpio-pxa.c:453: warning: unused variable 'next'

for the !CONFIG_OF case (after the below is fixed).

>  	struct pxa_gpio_chip *chips;
>  
>  	chips = devm_kzalloc(&pdev->dev, nbanks * sizeof(*chips), GFP_KERNEL);
> @@ -468,6 +447,7 @@ static int pxa_init_gpio_chip(struct platform_device *pdev, int gpio_end,
>  		return -ENOMEM;
>  	}
>  
> +	next = of_get_next_child(np, NULL);

This does not compile for the !CONFIG_OF case, so at least,
you should #ifdef the above line or probably the better solution would be
to stub out the of_get_next_child() in the OF code (probably include/linux/of.h).

>  	for (i = 0, gpio = 0; i < nbanks; i++, gpio += 32) {
>  		struct gpio_chip *gc = &chips[i].chip;
>  
> @@ -495,7 +475,10 @@ static int pxa_init_gpio_chip(struct platform_device *pdev, int gpio_end,
>  		gc->set = pxa_gpio_set;
>  		gc->to_irq = pxa_gpio_to_irq;
>  #ifdef CONFIG_OF_GPIO
> -		gc->of_node = pxa_gpio_of_node;
> +		gc->of_node = next;
> +		next = of_get_next_child(np, next);
> +		of_node_put(gc->of_node);
> +
>  		gc->of_xlate = pxa_gpio_of_xlate;
>  		gc->of_gpio_n_cells = 2;
>  #endif
> 

-- 
Regards,
Igor.



More information about the linux-arm-kernel mailing list