[PATCH 2/4 v11] clk, highbank: Prevent glitches in non-bypass reset mode

[Mark Langsdorf]

The highbank clock will glitch with the current code if the
clock rate is reset without relocking the PLL. Program the PLL
correctly to prevent glitches.

Signed-off-by: Mark Langsdorf <mark.langsdorf at calxeda.com>
Signed-off-by: Rob Herring <rob.herring at calxeda.com>
Acked-by: Mike Turquette <mturquette at linaro.org>
---
Changes from v6, v7, v8, v9, v10
        None.
Changes from v5
        Added Mike Turquette's ack.
Changes from v4
        None.
Changes from v3
        Changelog text and patch name now correspond to the actual patch.
        was clk, highbank: remove non-bypass reset mode.
Changes from v2
        None.
Changes from v1
        Removed erroneous reformating.

 drivers/clk/clk-highbank.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/clk/clk-highbank.c b/drivers/clk/clk-highbank.c
index 52fecad..3a0b723 100644
--- a/drivers/clk/clk-highbank.c
+++ b/drivers/clk/clk-highbank.c
@@ -182,8 +182,10 @@ static int clk_pll_set_rate(struct clk_hw *hwclk, unsigned long rate,
 		reg |= HB_PLL_EXT_ENA;
 		reg &= ~HB_PLL_EXT_BYPASS;
 	} else {
+		writel(reg | HB_PLL_EXT_BYPASS, hbclk->reg);
 		reg &= ~HB_PLL_DIVQ_MASK;
 		reg |= divq << HB_PLL_DIVQ_SHIFT;
+		writel(reg | HB_PLL_EXT_BYPASS, hbclk->reg);
 	}
 	writel(reg, hbclk->reg);
 
-- 
1.7.11.7