[PATCH v3 1/4] drivers: usb: phy: add a new driver for usb part of control module
balbi at ti.com
Fri Jan 25 03:45:01 EST 2013
On Fri, Jan 25, 2013 at 02:12:41PM +0530, kishon wrote:
> On Friday 25 January 2013 01:18 PM, Felipe Balbi wrote:
> >On Thu, Jan 24, 2013 at 09:32:46PM -0800, Stephen Warren wrote:
> >>On 01/24/2013 06:19 PM, Kishon Vijay Abraham I wrote:
> >>>Added a new driver for the usb part of control module. This has an API
> >>>to power on the USB2 phy and an API to write to the mailbox depending on
> >>>whether MUSB has to act in host mode or in device mode.
> >>>Writing to control module registers for doing the above task which was
> >>>previously done in omap glue and in omap-usb2 phy will be removed.
> >>>diff --git a/Documentation/devicetree/bindings/usb/usb-phy.txt b/Documentation/devicetree/bindings/usb/usb-phy.txt
> >>This file seems to be specific to the TI USB PHYs, not all USB PHYs;
> >>shouldn't it be renamed ti-usb-phy.txt, or even better renamed to match
> >>the compatible value it documents, giving ti,omap-usb2.txt?
> >could be, but that can be done as a separate patch. It's not part of
> >>> add the address of control module dev conf register until a driver for
> >>> control module is added
> >>>+Optional properties:
> >>>+ - ctrl_module : phandle of the control module used by PHY driver to power on
> >>>+ the PHY.
> >>DT property names generally use - not _ as the word separator.
> >fair enough, Kishon, can you fix this up ?
> Sure. Will post a patch..
Great, notice that I've already applied some of your patches to my tree.
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 836 bytes
Desc: Digital signature
More information about the linux-arm-kernel