[RESEND PATCH v5 3/7] usb: chipidea: add otg id switch and vbus connect/disconnect detect

[Peter Chen]

On Thu, Jan 24, 2013 at 05:25:17PM +0200, Alexander Shishkin wrote:
> Peter Chen <peter.chen at freescale.com> writes:
> 
> > The main design flow is the same with msm otg driver, that is the id and
> > vbus interrupt are handled at core driver, others are handled by
> > individual drivers.
> >
> > - At former design, when switch usb role from device->host, it will call
> > udc_stop, it will remove the gadget driver, so when switch role
> > from host->device, it can't add gadget driver any more.
> > At new design, when role switch occurs, the gadget just calls
> > usb_gadget_vbus_disconnect/usb_gadget_vbus_connect as well as
> > reset controller, it will not free any device/gadget structure
> >
> > - Add vbus connect and disconnect to core interrupt handler, it can
> > notify udc driver by calling usb_gadget_vbus_disconnect
> > /usb_gadget_vbus_connect.
> >
> > Signed-off-by: Peter Chen <peter.chen at freescale.com>
> 
> [snip]
> 
> > @@ -483,6 +614,17 @@ static int ci_hdrc_probe(struct platform_device *pdev)
> >  		goto rm_wq;
> >  	}
> >  
> > +	otgsc = hw_read(ci, OP_OTGSC, ~0);
> > +	/*
> > +	 * if it is device mode:
> > +	 * - Enable vbus detect
> > +	 * - If it has already connected to host, notify udc
> > +	 */
> > +	if (ci->role == CI_ROLE_GADGET) {
> > +		ci_enable_otg_interrupt(ci, OTGSC_BSVIE);
> > +		ci_handle_vbus_change(ci);
> > +	}
> > +
> 
> Actually, this doesn't work, neither here, nor in udc_start(), where the
> next patch moves it. If you start in host role with A plug, unplug it,
> plug B and load a gadget module,

When we unplug A, device's role start will be called, that is
udc_id_switch_for_device in my patch, it will enable vbus interrupt.
Then, when we plug B, there will be an vbus interrupt, then the
ci->vbus_active will be set, then when we load a gadget module, 
the enumeration will begin like I said at last email.

Ok, I say "fully tested" means I tested cases for my development, which
includes: host/device is plugged during boots up, device/host switch,
host only controller, load gadget before/next cable plugs in. If you
think it is not enough, I will skip "fully" when sends next version patch.


-- 

Best Regards,
Peter Chen