[PATCH v3 1/1 net-next] net: fec: enable pause frame to improve rx prefomance for 1G network

Ben Hutchings bhutchings at solarflare.com
Thu Jan 24 11:49:33 EST 2013


On Thu, 2013-01-24 at 10:16 +0800, Frank Li wrote:
> 2013/1/24 Ben Hutchings <bhutchings at solarflare.com>:
> > On Thu, 2013-01-17 at 10:55 +0800, Frank Li wrote:
> >> The limition of imx6 internal bus cause fec can't achieve 1G perfomance.
> >> There will be many packages lost because FIFO over run.
> >>
> >> This patch enable pause frame flow control.
> > [...]
> >> --- a/drivers/net/ethernet/freescale/fec.c
> >> +++ b/drivers/net/ethernet/freescale/fec.c
> > [...]
> >> +static int fec_enet_set_pauseparam(struct net_device *ndev,
> >> +                                struct ethtool_pauseparam *pause)
> >> +{
> >> +     struct fec_enet_private *fep = netdev_priv(ndev);
> >> +
> >> +     if (pause->tx_pause != pause->rx_pause) {
> >> +             netdev_info(ndev,
> >> +                     "hardware only support enable/disable both tx and rx");
> >> +             return -EINVAL;
> >> +     }
> >> +
> >> +     fep->pause_flag = 0;
> >> +
> >> +     /* tx pause must be same as rx pause */
> >> +     fep->pause_flag |= pause->rx_pause ? FEC_PAUSE_FLAG_ENABLE : 0;
> >> +     fep->pause_flag |= pause->autoneg ? FEC_PAUSE_FLAG_AUTONEG : 0;
> >> +
> >> +     if (pause->rx_pause || pause->autoneg) {
> >> +             fep->phy_dev->supported |= ADVERTISED_Pause;
> >> +             fep->phy_dev->advertising |= ADVERTISED_Pause;
> >> +     } else {
> >> +             fep->phy_dev->supported &= ~ADVERTISED_Pause;
> >> +             fep->phy_dev->advertising &= ~ADVERTISED_Pause;
> >> +     }
> > [...]
> >
> > Why is this changing the supported flags, i.e. device capabilities?  You
> > need to leave those flags alone and reject an attempt to enable pause
> > frames on a device that doesn't support them.
> 
> I go through phylib, I have not found good place set ADVERTISED_Pause
> capabilities.
> genphy_config_init never check Pause capabilities.

I agree that phylib can't initialise pause capabilities because those
depend on the MAC.  But look at which function I'm quoting: this is the
ethtool operation, which shouldn't change capabilities.

Ben.

-- 
Ben Hutchings, Staff Engineer, Solarflare
Not speaking for my employer; that's the marketing department's job.
They asked us to note that Solarflare product names are trademarked.




More information about the linux-arm-kernel mailing list