[PATCH 2/5] ARM: at91: at91sam9x5: add DT parameters to enable PMECC

[Josh Wu]

Default ecc correctable setting is 2bits in 512 bytes.

Signed-off-by: Josh Wu <josh.wu at atmel.com>
---
 arch/arm/boot/dts/at91sam9x5.dtsi   |    4 ++++
 arch/arm/boot/dts/at91sam9x5cm.dtsi |    5 ++++-
 2 files changed, 8 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/at91sam9x5.dtsi b/arch/arm/boot/dts/at91sam9x5.dtsi
index 3a47cf9..ecfafcf 100644
--- a/arch/arm/boot/dts/at91sam9x5.dtsi
+++ b/arch/arm/boot/dts/at91sam9x5.dtsi
@@ -498,7 +498,11 @@
 			#address-cells = <1>;
 			#size-cells = <1>;
 			reg = <0x40000000 0x10000000
+			       0xffffe000 0x600		/* PMECC Registers */
+			       0xffffe600 0x200		/* PMECC Error Location Registers */
+			       0x00108000 0x18000	/* PMECC looup table in ROM code  */
 			      >;
+			atmel,pmecc-lookup-table-offset = <0x0 0x8000>;
 			atmel,nand-addr-offset = <21>;
 			atmel,nand-cmd-offset = <22>;
 			pinctrl-names = "default";
diff --git a/arch/arm/boot/dts/at91sam9x5cm.dtsi b/arch/arm/boot/dts/at91sam9x5cm.dtsi
index 31e7be2..4027ac7 100644
--- a/arch/arm/boot/dts/at91sam9x5cm.dtsi
+++ b/arch/arm/boot/dts/at91sam9x5cm.dtsi
@@ -26,7 +26,10 @@
 	ahb {
 		nand0: nand at 40000000 {
 			nand-bus-width = <8>;
-			nand-ecc-mode = "soft";
+			nand-ecc-mode = "hw";
+			atmel,has-pmecc;	/* Enable PMECC */
+			atmel,pmecc-cap = <2>;
+			atmel,pmecc-sector-size = <512>;
 			nand-on-flash-bbt;
 			status = "okay";
 
-- 
1.7.9.5