[PATCH v8 01/22] USB: ehci-omap: Don't free gpios that we didn't request

Roger Quadros rogerq at ti.com
Fri Jan 18 07:36:44 EST 2013


This driver does not request any gpios so don't free them.
Fixes L3 bus error on multiple modprobe/rmmod of ehci_hcd
with ehci-omap in use.

Without this patch, EHCI will break on repeated insmod/rmmod
of ehci_hcd for all OMAP2+ platforms that use EHCI and
set 'phy_reset = true' in usbhs_omap_board_data.
i.e.

board-3430sdp.c:	.phy_reset  = true,
board-3630sdp.c:	.phy_reset  = true,
board-am3517crane.c:	.phy_reset  = true,
board-am3517evm.c:	.phy_reset  = true,
board-cm-t3517.c:	.phy_reset  = true,
board-cm-t35.c:	.phy_reset  = true,
board-devkit8000.c:	.phy_reset  = true,
board-igep0020.c:	.phy_reset = true,
board-igep0020.c:	.phy_reset = true,
board-omap3beagle.c:	.phy_reset  = true,
board-omap3evm.c:	.phy_reset  = true,
board-omap3pandora.c:	.phy_reset  = true,
board-omap3stalker.c:	.phy_reset = true,
board-omap3touchbook.c:	.phy_reset  = true,
board-omap4panda.c:	.phy_reset  = false,
board-overo.c:	.phy_reset  = true,
board-zoom.c:	.phy_reset		= true,

CC: Alan Stern <stern at rowland.harvard.edu>
Cc: stable at vger.kernel.org

Signed-off-by: Roger Quadros <rogerq at ti.com>
Reviewed-by: Felipe Balbi <balbi at ti.com>
Acked-by: Alan Stern <stern at rowland.harvard.edu>
---
 drivers/usb/host/ehci-omap.c |    8 --------
 1 files changed, 0 insertions(+), 8 deletions(-)

diff --git a/drivers/usb/host/ehci-omap.c b/drivers/usb/host/ehci-omap.c
index ac17a7c..e9d9b09 100644
--- a/drivers/usb/host/ehci-omap.c
+++ b/drivers/usb/host/ehci-omap.c
@@ -288,7 +288,6 @@ static int ehci_hcd_omap_remove(struct platform_device *pdev)
 {
 	struct device *dev				= &pdev->dev;
 	struct usb_hcd *hcd				= dev_get_drvdata(dev);
-	struct ehci_hcd_omap_platform_data *pdata	= dev->platform_data;
 
 	usb_remove_hcd(hcd);
 	disable_put_regulator(dev->platform_data);
@@ -298,13 +297,6 @@ static int ehci_hcd_omap_remove(struct platform_device *pdev)
 	pm_runtime_put_sync(dev);
 	pm_runtime_disable(dev);
 
-	if (pdata->phy_reset) {
-		if (gpio_is_valid(pdata->reset_gpio_port[0]))
-			gpio_free(pdata->reset_gpio_port[0]);
-
-		if (gpio_is_valid(pdata->reset_gpio_port[1]))
-			gpio_free(pdata->reset_gpio_port[1]);
-	}
 	return 0;
 }
 
-- 
1.7.4.1




More information about the linux-arm-kernel mailing list