[PATCH V2 3/3] ARM: davinci: da850: add NAND driver entries

[Sekhar Nori]

On 1/15/2013 4:06 PM, Kumar, Anil wrote:
> On Thu, Jan 10, 2013 at 17:49:13, Nori, Sekhar wrote:
>> On 1/10/2013 1:07 PM, Kumar, Anil wrote:
>>> On Wed, Jan 09, 2013 at 18:17:46, Nori, Sekhar wrote:
>>
>>> I do not think that it is good idea to move NAND pin mux information
>>> into da850.dtsi because this information is evm specific.
>>> if we will use this approach then we must use the same approach for
>>> other modules also as ASoC etc.   
>>
>> Why do you consider this EVM specific. IOW, which pins do you see
>> changing on another board? BTW, if there are additional pins needed than
>> what are listed, we can always add more pinux entries in the .dts files.
>> The pins present in dtsi file should the base case.
>  
> Ok, we can use this approach for DaVinci as its SoC modules do not
> have multiple pin configuration option. I will do the changes in 
> next patch series.

You could do this even if this was the case by defining multiple pin groups.

Thanks,
Sekhar