[RFC v2 14/18] ARM: OMAP2+: AM33XX: control: Add some control module registers and APIs

[Santosh Shilimkar]

On Wednesday 09 January 2013 03:07 PM, Bedia, Vaibhav wrote:
> On Wed, Jan 09, 2013 at 13:01:03, Shilimkar, Santosh wrote:
>> On Wednesday 09 January 2013 11:08 AM, Bedia, Vaibhav wrote:
>>> On Tue, Jan 08, 2013 at 20:51:08, Shilimkar, Santosh wrote:
>>>> On Monday 31 December 2012 06:37 PM, Vaibhav Bedia wrote:
>>>>> Add minimal APIs for writing to the IPC and the M3_TXEV registers
>>>>> in the Control module. These will be used in a subsequent patch which
>>>>> adds suspend-resume support for AM33XX.
>>>>>
>>>>> Signed-off-by: Vaibhav Bedia <vaibhav.bedia at ti.com>
>>>>> Cc: Tony Lingren <tony at atomide.com>
>>>>> Cc: Santosh Shilimkar <santosh.shilimkar at ti.com>
>>>>> Cc: Benoit Cousson <b-cousson at ti.com>
>>>>> Cc: Paul Walmsley <paul at pwsan.com>
>>>>> Cc: Kevin Hilman <khilman at deeprootsystems.com>
>>>>> Cc: Vaibhav Hiremath <hvaibhav at ti.com>
>>>>> ---
>>>> On Control module, we are trying to move driver/module
>>>> specific code to respective drivers. Can you not
>>>> add below code to ipc related driver component.
>>>>
>>>> If not, then patch as such is fine with me.
>>>>
>>>
>>> I had it in the pm33xx.c in the previous version. Kevin had asked me to
>>> move it to control.c. Should I revert move it back there?
>>>
>> pm33xx.c is not the right place. I was hoping to move to some driver.
>> If that is not possible then leave it in control module.
>>
>
> I think I'll leave it here for now. Could I have you ack in that case?
>
Yep.
Acked-by: Santosh Shilimkar <santosh.shilimkar at ti.com>