[PATCH v4 0/3] ARM/dts: omap3: Add DT support for IGEP devices

[Javier Martinez Canillas]

On Tue, Jan 8, 2013 at 5:13 PM, Benoit Cousson <b-cousson at ti.com> wrote:
> Hi Javier,
>
> On 12/19/2012 02:33 PM, Javier Martinez Canillas wrote:
>> IGEP technology devices are TI OMAP3 SoC based industrial embedded
>> and computer-on-module boards. This patch-set adds initial device
>> tree support for these devices.
>>
>> The device trees allows to boot from an MMC and are working all the
>> components that already have device tree support on OMAP3 SoCs:
>>
>> - MMC/SD
>> - UARTs
>> - GPIO LEDs
>> - TWL4030 codec audio
>> - pinmux/pinconf pinctrl
>>
>> Some peripheral are still not working such as Flash storage and
>> Ethernet but support for these will also be included once the
>> OMAP GPMC device tree binding patches land on mainline.
>>
>> This is a v4 of the patch-set that adds MMC mux pins setup and
>> fixes a build issue due recent changes on twl4030.dtsi.
>>
>> The patch-set is composed of the following patches:
>>
>> [PATCH v4 1/3] ARM/dts: omap3: Add generic DT support for IGEP devices
>> [PATCH v4 2/3] ARM/dts: omap3: Add support for IGEPv2 board
>> [PATCH v4 3/3] ARM/dts: omap3: Add support for IGEP COM Module
>
> I've just applied your series for 3.9 on top of 3.8-rc2 and had to update the Makefile that was different in the base you used. At the same time I updated the subjects to use "ARM: dts:" prefix to be compliant with the latest trend :-)
>
> The patches are available here:
> git://git.kernel.org/pub/scm/linux/kernel/git/bcousson/linux-omap-dt.git for_3.9/dts
>
> Regards,
> Benoit
>
>
> --

Great, thanks a lot Benoit!

Best regards,
Javier