[PATCH 4/4] ARM: tegra: Set SCU base address dynamically from DT
hdoyu at nvidia.com
Thu Jan 3 01:38:48 EST 2013
Stephen Warren <swarren at wwwdotorg.org> wrote @ Wed, 2 Jan 2013 20:02:53 +0100:
> On 12/16/2012 11:18 PM, Hiroshi Doyu wrote:
> > Set Snoop Control Unit(SCU) register base address dynamically from DT.
> Hiroshi, what's the status on this patch series? I think Rob had
> comments/objections on patch 4; are you going to post an updated series,
> or is this series replaced by patch 3 in your Tegra114 series?
As Rob suggested, at least, SCU base address should be detected in
common code, scu_of_init() even if DT /cpus is the primary way to
detect # of cores. I'll repost later.
This patch can be done independent of Tegra114 series.
More information about the linux-arm-kernel