[PATCH 3/5] gpio/omap: Add DT support to GPIO driver

[Jon Hunter]

On 02/26/2013 04:01 AM, Javier Martinez Canillas wrote:

[snip]

> I was wondering if the level/edge settings for gpios is working on OMAP.
> 
> I'm adding DT support for an SMSC911x ethernet chip connected to the
> GPMC for an OMAP3 SoC based board.
> 
> In the smsc911x driver probe function (smsc911x_drv_probe() in
> drivers/net/ethernet/smsc/smsc911x.c), a call to request_irq() with
> the flag IRQF_TRIGGER_LOW is needed because of the wiring on my board.
> 
> Reading the gpio-omap.txt documentation it says that #interrupt-cells
> should be <2> and that a value of 8 is "active low level-sensitive".
> 
> So I tried this:
> 
> &gpmc {
> 	ethernet at 5,0 {
> 		pinctrl-names = "default";
> 		pinctrl-0 = <&smsc911x_pins>;
> 		compatible = "smsc,lan9221", "smsc,lan9115";
> 		reg = <5 0 0xff>; /* CS5 */
> 		interrupt-parent = <&gpio6>;
> 		interrupts = <16 8>; /* gpio line 176 */
> 		interrupt-names = "smsc911x irq";
> 		vmmc-supply = <&vddvario>;
> 		vmmc_aux-supply = <&vdd33a>;
> 		reg-io-width = <4>;

By the way, reg-io-width for omap does not look correct. The GPMC only
supports 8-bit or 16-bit devices IIRC. I believe all my omap boards use
16-bit.

Cheers
Jon