[PATCH 17/40] ab8500-fg: Allow capacity to raise from 1% when charging

[Lee Jones]

From: Hakan Berg <hakan.berg at stericsson.com>

When battery capacity was going below 1% fg is not supposed
to report 0% unless we've got the LOW_BAT IRQ, no matter
what the FG-algorithm says. This made fg get stuck at 1% if
charger is connected when capacity is 1%.

Signed-off-by: Hakan BERG <hakan.berg at stericsson.com>
Signed-off-by: Lee Jones <lee.jones at linaro.org>
Reviewed-by: Marcus COOPER <marcus.xm.cooper at stericsson.com>
Reviewed-by: Srinidhi KASAGAR <srinidhi.kasagar at stericsson.com>
---
 drivers/power/ab8500_fg.c |    6 ++----
 1 file changed, 2 insertions(+), 4 deletions(-)

diff --git a/drivers/power/ab8500_fg.c b/drivers/power/ab8500_fg.c
index 44d8faa..f596883 100644
--- a/drivers/power/ab8500_fg.c
+++ b/drivers/power/ab8500_fg.c
@@ -1354,9 +1354,6 @@ static void ab8500_fg_check_capacity_limits(struct ab8500_fg *di, bool init)
 			 * algorithm says.
 			 */
 			di->bat_cap.prev_percent = 1;
-			di->bat_cap.permille = 1;
-			di->bat_cap.prev_mah = 1;
-			di->bat_cap.mah = 1;
 			percent = 1;
 
 			changed = true;
@@ -1768,9 +1765,10 @@ static void ab8500_fg_algorithm(struct ab8500_fg *di)
 			ab8500_fg_algorithm_discharging(di);
 	}
 
-	dev_dbg(di->dev, "[FG_DATA] %d %d %d %d %d %d %d %d %d "
+	dev_dbg(di->dev, "[FG_DATA] %d %d %d %d %d %d %d %d %d %d "
 		"%d %d %d %d %d %d %d\n",
 		di->bat_cap.max_mah_design,
+		di->bat_cap.max_mah,
 		di->bat_cap.mah,
 		di->bat_cap.permille,
 		di->bat_cap.level,
-- 
1.7.10.4