[PATCH v6 08/10] ARM: dt: Add references to tegra_car clocks

[Stephen Warren]

On 02/13/2013 04:38 AM, Peter De Schrijver wrote:
> On Tue, Feb 12, 2013 at 06:24:05PM +0100, Stephen Warren wrote:
>> On 02/11/2013 04:04 AM, Peter De Schrijver wrote:
>>> Add references to tegra_car clocks for the basic device nodes.
>>
>> In this patch, you also need to remove the "clock-frequency" properties
>> from tegra114-*.dts board files.
> 
> That would probably break bisectability no?

Oh right, I read the patch order backwards. You can fix this by moving
this patch to the end of the series.

> I think this needs to be done in a separate patch.

To avoid bisect issues, the clock-frequency property should be removed
in the same patch that adds the clocks property, or after it.

> Also, the UARTD enabling in init_table[] can then be removed.

You still need to initialize all the UART clocks in init_table[]. This
is required to make sure the clocks have the correct parent. Without
this explicit initialization, on Tegra30 at least, it was found that
UART C didn't work correctly for Bluetooth since the default parent was
something that wasn't generating the expected frequency.

Before removing the clock-frequency property, you also need to make sure
that init_table[] forces the UART clock on, otherwise since nothing will
clk_get()/enable() the UART clock, clk_disable_unused() will disable it.
After removing clock-frequency property, of_serial.c will
clk_get()/enable() the UART clock based on the clocks property, and
hence init_table[] doesn't need to force the UART clock on.