[PATCH 0/5 v3] at91: PMECC: enable PMECC in dt for at91sam9x5ek, at91sam9n12ek

[Josh Wu]

Hi,

Just a ping. Any feedback for this v3 patch?

Best Regards,
Josh Wu

On 1/23/2013 8:47 PM, Josh Wu wrote:
> Those patches will enable PMECC in dt parameters for at91sam9x5ek and
> at91sam9n12ek.
>
> The PMECC driver will check minimum required ecc on ONFI parameter from NAND
> flash.
>
> If pmecc-cap, pmecc-sector-size in dts file is specified, use those two.
> otherwise, set those according to NAND flash ONFI parameters.
>
> If the pmecc-cap, pmecc-sector-size in dts are different with ecc requirement
> in ONFI, print out a warning.
>
>
> For the following compile error:
>    ERROR (phandle_references): Reference to non-existent node or label "pinctrl_ssc0_tx"
>
>    ERROR: Input tree has errors, aborting (use -f to force output)
>    make[2]: *** [arch/arm/boot/dts/at91sam9g20ek.dtb] Error 2
>
> the fixes are already merged in Linux mainline in v3.8-rc4.
> you can find in:
>   544ae6b2e676c3c37fb8c93ef9327932fc2e5bc2 (ARM: at91/dts: add pinctrl support for SSC peripheral)
>   ea03c81521bde526570e1dec96eaa21fe5ac84a2 (ASoC: atmel-ssc: add pinctrl selection to driver)
>
>
> Change logs:
> v2: rebase to v3.8-rc3. And wrapped the commit message.
>
> v3: big chages:
>    1. reduce the PMECC lookup table mapping. Just the lookup table not whole
>       ROM code according to J.C's suggestion.
>    2. use simpler strategy to handle pmecc-cap, pmecc-sector-size:
>       * make pmecc-cap, pmecc-sector-size optional.
>       * If pmecc-cap, pmecc-sector-size are not set, use ONFI ecc parameters.
>         otherwise, use those in DTS file.
>       * print out a warning if PMECC use different ecc bits or sector size
>         from ONFI ecc parameters.
>
> Josh Wu (5):
>    MTD: atmel_nand: avoid to report an error when lookup table offset is
>      0.
>    ARM: at91: at91sam9x5: add DT parameters to enable PMECC
>    ARM: at91: at91sam9n12: add DT parameters to enable PMECC
>    MTD: atmel_nand: make pmecc-cap, pmecc-sector-size in dts is
>      optional.
>    MTD: at91: atmel_nand: for PMECC, add code to check the ONFI
>      parameter ECC requirement.
>
>   arch/arm/boot/dts/at91sam9n12.dtsi  |    3 +-
>   arch/arm/boot/dts/at91sam9n12ek.dts |    5 +-
>   arch/arm/boot/dts/at91sam9x5.dtsi   |    4 +
>   arch/arm/boot/dts/at91sam9x5cm.dtsi |    5 +-
>   drivers/mtd/nand/atmel_nand.c       |  141 +++++++++++++++++++++++++++++------
>   5 files changed, 131 insertions(+), 27 deletions(-)
>