[PATCH 1/2] ARM: dts: OMAP3: Add GPMC controller

[Tony Lindgren]

* Javier Martinez Canillas <javier at dowhile0.org> [130204 04:00]:
> On Mon, Feb 4, 2013 at 11:36 AM, Florian Vaussard
> > Great, the smsc911x was on my TODO list, I can cross it out :) BTW,
> > do you have a public git for this, so I can test your work on my setup?
> >
> 
> Yes, it is the gpmc-smsc911x-wip branch on my github linux tree [1]
> 
> That branch is Linus master tree + linux-omap/omap-for-v3.9/gpmc +
> linux-omap-dt/for_3.9/dts
> 
> plus these patches:
> 
> Javier Martinez Canillas (4):
>       ARM: OMAP: gpmc-smsc911x: add DT dev node init function
>       ARM: OMAP: gpmc: add support for gpmc-smsc911x child nodes
>       ARM: dts: OMAP: Add an GPMC node for OMAP3
>       ARM: dts: omap3-igep0020: Add SMSC911x LAN chip support
> 
> You can browse these patches here [2].
> 
> With these patches I have ethernet working on my IGEPv2 but this board
> uses an OMAP GPIO pin as the smsc911x IRQ line, so it needs to set a
> mux pin (mcspi1_cs2.gpio_176 INPUT | MODE4) or it will fallback on
> poll mode.

Great, that's good news :)

> For some reasons I still couldn't figure out (I'm still learning about
> Device Trees) adding:
> 
>        pinctrl = devm_pinctrl_get_select_default(&pdev->dev);
> 
> to the gpmc-smsc911x child node parse function (gpmc_smsc911x_init_dt)
> didn't have a functional effect and I had to initialize the defined
> pinctrl-single pins for the smsc911x in the omap3_pmx_core device node
> instead of pmc_smsc911x at 0 as I do for other devices (mmc, uarts, etc).

Maybe this is related to the initcall ordering..
 
> So I just removed the devm_pinctrl_get_select_default() call in
> gpmc_smsc911x_init_dt() in for this RFC.
> 
> I don't know if this is because arch/arm/mach-omap2/gpmc-smsc911x.c is
> not a real platform driver (is just a wrapper/helper function) and
> doesn't have a probe function.

..that function just initializes the pdata for smsc911x driver, and
should not be a driver. You need to add devm_pinctrl_get_select_default()
to the probe of smsc911x or the GPMC probe.
 
> Which brings me to the question if my approach of adding a binding for
> gpmc-smsc911x is correct or if we should extend/use the binding that
> already exist for smsc911x
> (Documentation/devicetree/bindings/net/smsc911x.txt).

We should use the existing smsc911x binding, then have a separate GPMC
binding for the GPMC driver.

Regards,

Tony 
 
> [1]: git://github.com/martinezjavier/linux.git
> [2]: https://github.com/martinezjavier/linux/commits/gpmc-smsc911x-wip
> [3]: http://omappedia.org/wiki/Bootloader_Project#SYSBOOT_Pins