[PATCH] pinctrl: at91: add support for OUTPUT config

[Linus Walleij]

On Wed, Aug 28, 2013 at 3:46 PM, Linus Walleij <linus.walleij at linaro.org> wrote:
> On Tue, Aug 27, 2013 at 4:51 PM, Boris BREZILLON
> <b.brezillon at overkiz.com> wrote:
>
>> Add support for pin output control through the pinctrl config:
>>  - support enabling/disabling output on a given pin
>>  - support output level setting (high or low)
>>
>> Signed-off-by: Boris BREZILLON <b.brezillon at overkiz.com>
>
> NAK.
>
> We already have this:
>
>  * @PIN_CONFIG_OUTPUT: this will configure the pin in output, use argument
>  *      1 to indicate high level, argument 0 to indicate low level.
>
> It also has device tree bindings:
>
> output-low              - set the pin to output mode with low level
> output-high             - set the pin to output mode with high level

Bah maybe I'm misunderstanding :-(

So this is not part of the generic pin config series, but something
stand-alone to augment the existing driver to do this?

So I just apply this patch right off then?

Yours,
Linus Walleij