[PATCHv3 0/9] ARM: OMAP2+: AM33XX: Add suspend-resume support

[Kevin Hilman]

Hi Dave,

Dave Gerlach <d-gerlach at ti.com> writes:

> On 08/19/2013 04:23 AM, Gururaja Hebbar wrote:
>> On 8/6/2013 11:19 PM, Dave Gerlach wrote:
>>> Hi,
>>>
>>> This is the third version of the patch series for adding basic suspend-resume
>>> support for AM33XX, previously submitted by Vaibhav Bedia. This patchset
>>> is based on 3.11-rc4 and depends on a forthcoming patchset from Suman Anna
>>> that adds mailbox support for the wkup_m3. The patches at [1], [2], and [3] are
>>> required for the pm code to properly suspend and resume.
>>>
>>> The PM code uses the firmware interface and expects the userspace to load
>>> the WKUP_M3 binary before the suspend-resume functionality is made available.
>>> The binary file (and the source-code for WKUP_M3) can be obtained from the
>>> 'next2' branch at [4]. The WKUP_M3 binary can either be loaded post bootup
>>> via the sysfs entry './sys/devices/ocp.2/wkup_m3.4/firmware' or it can be
>>> included in the kernel image as part of the build process.
>>>
>>> Suspend to mem is tested on am335x-bone and am335x-evm.
>>>
>>> More details on AM335x suspend-resume are provided within the commit logs
>>> for each patch.
>>
>> can you share the working repo which has all these patches applied?
>>
>> Thanks & Regards
>> Gururaja
>>
>
> The working repo for this version of the patch series can be found here:
>
> git://github.com/dgerlach/linux-pm.git am335x-3.11rc4-suspend-resume

I tried this branch on my beaglebone black, and it's not fully resuming.
Suspend seems to be working (power draw goes from ~1W to ~130mW) and
pressing a key on the UART seems to be waking up the SoC (power draw
goes to ~600mW) but I don't ever get the console back.

Is there a specific version of the firmware I should be using?

Kevin