[PATCH RFC v2 5/5] spmi: document the PMIC arbiter SPMI bindings

[Stephen Warren]

On 08/09/2013 02:37 PM, Josh Cartwright wrote:

Patch description?

> diff --git a/Documentation/devicetree/bindings/spmi/qcom,spmi-pmic-arb.txt b/Documentation/devicetree/bindings/spmi/qcom,spmi-pmic-arb.txt

> +Required properties:
> +- compatible : should be "qcom,spmi-pmic-arb".
> +- reg-names  : should be "core", "intr", "cnfg"

> +- reg : offset and length of the PMIC Arbiter Core register map.
> +- reg : offset and length of the PMIC Arbiter Interrupt controller register map.
> +- reg : offset and length of the PMIC Arbiter Configuration register map.

This seems like it's defining the "reg" property 3 times each with a
different meaning. It'd be better to say something like:

reg : register specifier. Must contain 3 entries, in the following
order: core registers, interrupt register, configuration registers.

> +	qcom,spmi at fc4c0000 {
...
> +		qcom,pm8841 at 4 {

Node names typically don't include a vendor prefix. For the first
instance above, I think just "spmi at fc4c0000" or even just "spmi" would
be appropriate here; the latter being best in the case where there's
only 1 SPMI controller and hence no need to include the unit address for
uniqueness.