[PATCH 0/9] USB: phy: phy-nop: Manage RESET GPIO in the driver
rogerq at ti.com
Wed Aug 14 09:58:04 EDT 2013
Modelling the RESET line as a regulator supply wasn't a good idea
as it abuses the regulator framework and makes adaptation
code/data more complex.
Instead, manage the RESET gpio line directly in the driver.
This also makes us easy to migrate to a dedicated GPIO RESET controller
whenever it becomes available. As of now, it doesn't seem to be making
it into 3.12.
*NOTE:* As there are changes to platform data, Patch 1 needs to be shared
between the arm-soc tree and usb tree.
Patch 1 is available at repo
Patch 2 contains the phy-nop driver changes
Patches 3 and 4 adapt legacy boot code to the phy-nop driver changes.
Patches 5, 6 and 7 adapt DT data to the binding changes.
Patch 8 is cleanup of omap3-beagle DT.
Patch 9 adds USB host support to omap3-beagle-xm using the new binding.
Patches are based on v3.11-rc5.
Tested leacy boot on omap3-beagle and omap3-beagle-xm
Tested DT boot on omap3-beagle, omap3-beagle-xm and omap4-panda-es
Roger Quadros (9):
usb: phy: nop: Add gpio_reset to platform data
usb: phy: nop: Don't use regulator framework for RESET line
ARM: OMAP2+: omap-usb-host: Get rid of platform_data from struct
ARM: OMAP2+: usb-host: Adapt to USB phy-nop RESET line changes
ARM: dts: omap3-beagle: Use reset-gpios for hsusb2_reset
ARM: dts: omap4-panda: Use reset-gpios for hsusb1_reset
ARM: dts: omap5-uevm: Use reset-gpios for hsusb2_reset
ARM: dts: omap3-beagle: Make USB host pin naming consistent
ARM: dts: omap3-beagle-xm: Add USB Host support
.../devicetree/bindings/usb/usb-nop-xceiv.txt | 7 +-
arch/arm/boot/dts/omap3-beagle-xm.dts | 65 +++++++++++++++++---
arch/arm/boot/dts/omap3-beagle.dts | 37 ++++-------
arch/arm/boot/dts/omap4-panda-common.dtsi | 18 +-----
arch/arm/boot/dts/omap5-uevm.dts | 13 +----
arch/arm/mach-omap2/board-omap3beagle.c | 6 --
arch/arm/mach-omap2/usb-host.c | 18 +++---
arch/arm/mach-omap2/usb.h | 1 -
drivers/usb/phy/phy-nop.c | 48 +++++++++------
include/linux/usb/nop-usb-xceiv.h | 4 +-
10 files changed, 115 insertions(+), 102 deletions(-)
More information about the linux-arm-kernel