[PATCH 4/8] ARM: dts: mxs: add pin config for SSP3 interface

[Lothar Waßmann]

Signed-off-by: Lothar Waßmann <LW at KARO-electronics.de>
---
 arch/arm/boot/dts/imx28.dtsi |   15 +++++++++++++++
 1 files changed, 15 insertions(+), 0 deletions(-)

diff --git a/arch/arm/boot/dts/imx28.dtsi b/arch/arm/boot/dts/imx28.dtsi
index 7d7f277..6de6342 100644
--- a/arch/arm/boot/dts/imx28.dtsi
+++ b/arch/arm/boot/dts/imx28.dtsi
@@ -683,6 +683,21 @@
 					fsl,pull-up = <1>;
 				};
 
+				spi3_pins_a: spi3 at 0 {
+					reg = <0>;
+					fsl,pinmux-ids = <
+						0x3082 /* MX28_PAD_AUART2_RX__SSP3_D4 */
+						0x3092 /* MX28_PAD_AUART2_TX__SSP3_D5 */
+						0x2180 /* MX28_PAD_SSP3_SCK__SSP3_SCK */
+						0x2190 /* MX28_PAD_SSP3_MOSI__SSP3_CMD */
+						0x21A0 /* MX28_PAD_SSP3_MISO__SSP3_D0 */
+						0x21B0 /* MX28_PAD_SSP3_SS0__SSP3_D3 */
+					>;
+					fsl,drive-strength = <1>;
+					fsl,voltage = <1>;
+					fsl,pull-up = <0>;
+				};
+
 				usbphy0_pins_a: usbphy0 at 0 {
 					reg = <0>;
 					fsl,pinmux-ids = <
-- 
1.7.2.5