[PATCHv1] arm: armada: Add .dts file for Netgear ReadyNAS 102

Jason Cooper jason at lakedaemon.net
Mon Aug 5 09:44:57 EDT 2013


On Mon, Aug 05, 2013 at 03:25:21PM +0200, Gregory CLEMENT wrote:
> On 04/07/2013 23:16, Arnaud Ebalard wrote:
> > 
> > All hardware parts of the (Armada 370 based) NETGEAR ReadyNAS 102 are
> > supported by mainline kernel (USB 3.0 rear ports, USB 2.0 front port,
> > Gigabit controller and PHY, serial port, leds, buttons, SATA ports,
> > G762 fan controller) except for:
> > 
> >  - the Intersil ISL12057 I2C RTC Chip,
> >  - the Armada NAND controller.
> > 
> > Support for both of those is currently work in progress and does not
> > prevent boot.
> 
> If it is not too late you can add my
> 
> Acked-by: Gregory CLEMENT <gregory.clement at free-electrons.com>

Added.

> Just a nitpick:
> 
> For a better coherency in your file you could add an extra line before
> each sub-node as you have done for all the other nodes:

fixed.

thx,

Jason.



More information about the linux-arm-kernel mailing list