[PATCH 1/2] ARM: mvebu: add support for the AXP WiFi AP board

[Seif Mazareeb]

Post approval, but I've tested on my board too.
UART, USB3.0, mini-PCIe, SPI, Sata, and Ethernet - looking good.

Seif

-----Original Message-----
From: Jason Cooper [mailto:jason at lakedaemon.net] 
Sent: Saturday, August 03, 2013 11:12 AM
To: Thomas Petazzoni
Cc: Andrew Lunn; Gregory Clement; Lior Amsalem; Seif Mazareeb; linux-arm-kernel at lists.infradead.org; Ezequiel Garcia
Subject: Re: [PATCH 1/2] ARM: mvebu: add support for the AXP WiFi AP board

On Tue, Jul 30, 2013 at 05:44:50PM +0200, Thomas Petazzoni wrote:
> The AXP WiFi AP board is a Marvell platform based on the Armada XP
> MV78230 SoC. It has two mini-PCIe connectors, one USB 3.0 port powered 
> by a USB 3.0 controller on PCIe, two Ethernet ports, 1 GB of RAM, 1 GB 
> of NAND, 16 MB of SPI flash, one SATA port and one button, two UARTs
> 
> Successfully tested: USB 3.0 port, the mini-PCIe connectors, SPI 
> flash, Ethernet ports, SATA port, button, UART.
> 
> Untested: NAND flash, due to lack of mainline support for the Armada 
> 370/XP NAND controller for now.
> 
> Signed-off-by: Thomas Petazzoni <thomas.petazzoni at free-electrons.com>
> ---
>  arch/arm/boot/dts/Makefile                |   1 +
>  arch/arm/boot/dts/armada-xp-axpwifiap.dts | 164 
> ++++++++++++++++++++++++++++++
>  2 files changed, 165 insertions(+)
>  create mode 100644 arch/arm/boot/dts/armada-xp-axpwifiap.dts

Applied to mvebu/dt

thx,

Jason.