[PATCH 0/4] ARM: dove: DT updates for v3.11-rc2

[Jason Cooper]

On Mon, Jul 29, 2013 at 02:29:02PM +0200, Sebastian Hesselbarth wrote:
> This patch set comprises some DT updates and cleanup patches that
> piled up in the past. The first patch adds a cpu node for the
> Marvell Sheeva PJ4(A) CPU found on Dove SoCs. While touching the
> dtsi, also some nodes are renamed to achieve a consitent naming
> scheme. The second patch adds some common pinmux settings to
> the SoC's pinctrl node and moves the default pinctrl properties to
> the corresponding nodes. The third patch adds a node for the
> IR diode connected to a GPIO pin on SolidRun CuBox. Finally,
> the last patch adds an initial DT file for the Globalscale D2Plug
> which is also based on Marvell Dove SoC.
> 
> The whole patch set is based on v3.11-rc2 with DT part of
> mv643xx_eth and irqchip/clocksource patches applied.
> 
> Although this patches are Marvell Dove only, the whole set is also
> sent to devicetree mailing list to raise attention for potential DT
> binding review.
> 
> Sebastian Hesselbarth (4):
>   ARM: dove: add cpu device tree node
>   ARM: dove: add common pinmux functions to DT
>   ARM: dove: add GPIO IR receiver node to SolidRun CuBox
>   ARM: dove: add initial DT file for Globalscale D2Plug
> 
>  arch/arm/boot/dts/Makefile        |    1 +
>  arch/arm/boot/dts/dove-cubox.dts  |   30 ++---
>  arch/arm/boot/dts/dove-d2plug.dts |   69 +++++++++++
>  arch/arm/boot/dts/dove.dtsi       |  235 +++++++++++++++++++++++++++++++++----
>  4 files changed, 295 insertions(+), 40 deletions(-)
>  create mode 100644 arch/arm/boot/dts/dove-d2plug.dts

Whole series applied to mvebu/boards.

thx,

Jason.