[PATCH v3 4/5] ARM: shmobile: BOCK-W: add VIN and ML86V7667 support

[Sergei Shtylyov]

Hello.

On 04/23/2013 09:32 PM, Sergei Shtylyov wrote:

> From: Vladimir Barinov <vladimir.barinov at cogentembedded.com>
>
> Add ML86V7667 platform devices on BOCK-W board, configure VIN0/1 pins, and
> register VIN0/1 devices with the ML86V7667 specific platform data.
>
> Signed-off-by: Vladimir Barinov <vladimir.barinov at cogentembedded.com>
> [Sergei: some macro/comment cleanup; updated the copyrights, removed duplicate
> #include, annotated all platform data as '__initdata'.]
> Signed-off-by: Sergei Shtylyov <sergei.shtylyov at cogentembedded.com>
>
> ---
> Changes since version 2:
> - removed duplicate #include <linux/pinctrl/machine.h>;
> - annotated all platform data as '__initdata' since they're kmemdup()'ed while
>    registering the platform devices anyway;
> - resolved rejects, refreshed the patch.
>
>   arch/arm/mach-shmobile/board-bockw.c |   39 +++++++++++++++++++++++++++++++++++
>   1 file changed, 39 insertions(+)
>
> Index: renesas/arch/arm/mach-shmobile/board-bockw.c
> ===================================================================
> --- renesas.orig/arch/arm/mach-shmobile/board-bockw.c
> +++ renesas/arch/arm/mach-shmobile/board-bockw.c

[...]

> @@ -80,6 +101,16 @@ static const struct pinctrl_map bockw_pi
>   				  "sdhi0_data4", "sdhi0"),
>   	PIN_MAP_MUX_GROUP_DEFAULT("sh_mobile_sdhi.0", "pfc-r8a7778",
>   				  "sdhi0_wp", "sdhi0"),
> +	/* VIN0 */
> +	PIN_MAP_MUX_GROUP_DEFAULT("rcar_vin.0", "pfc-r8a7778",
> +				  "vin0_clk", "vin0"),
> +	PIN_MAP_MUX_GROUP_DEFAULT("rcar_vin.0", "pfc-r8a7778",
> +				  "vin0_data8", "vin0"),
> +	/* VIN1 */
> +	PIN_MAP_MUX_GROUP_DEFAULT("rcar_vin.1", "pfc-r8a7778",
> +				  "vin1_clk", "vin1"),
> +	PIN_MAP_MUX_GROUP_DEFAULT("rcar_vin.1", "pfc-r8a7778",
> +				  "vin1_data8", "vin1"),
>   };

     It turned out that VIN1 signal VI1_CLK conflicts with Ether signal 
ETH_REF_CLK.
So I'm a bit at a loss here: whether I should totally remove VIN1 device 
if I'm going
to add Ether device, or add a BOCK-W specific submenu to Kconfig, or add 
driver
specific #ifdef's in the code to disable VIN1 if sh_eth driver is 
enabled?...

WBR, Sergei