[PATCH 26/32] ARM: ux500: Supply UART's DMA configuration via Device Tree

[Lee Jones]

When requesting a channel, a DMA client needs to pass some pieces of
information such as; request channel, device type, channel type and
direction etc. Normally we do this in the form of platform data, but
when DT is enabled we need to pass it using the driver's bindings
instead.

Signed-off-by: Lee Jones <lee.jones at linaro.org>
---
 arch/arm/boot/dts/dbx5x0.dtsi |   17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/arch/arm/boot/dts/dbx5x0.dtsi b/arch/arm/boot/dts/dbx5x0.dtsi
index e2fa20f..bd0fe5f 100644
--- a/arch/arm/boot/dts/dbx5x0.dtsi
+++ b/arch/arm/boot/dts/dbx5x0.dtsi
@@ -569,18 +569,35 @@
 			compatible = "arm,pl011", "arm,primecell";
 			reg = <0x80120000 0x1000>;
 			interrupts = <0 11 0x4>;
+
+			dmas = <&dma 0 13 0x8>, /* Logical - DevToMem */
+			       <&dma 0 13 0x4>; /* Logical - MemToDev */
+			dma-names = "rx", "tx";
+
 			status = "disabled";
 		};
+
 		uart at 80121000 {
 			compatible = "arm,pl011", "arm,primecell";
 			reg = <0x80121000 0x1000>;
 			interrupts = <0 19 0x4>;
+
+			dmas = <&dma 0 12 0x8>, /* Logical - DevToMem */
+			       <&dma 0 12 0x4>; /* Logical - MemToDev */
+			dma-names = "rx", "tx";
+
 			status = "disabled";
 		};
+
 		uart at 80007000 {
 			compatible = "arm,pl011", "arm,primecell";
 			reg = <0x80007000 0x1000>;
 			interrupts = <0 26 0x4>;
+
+			dmas = <&dma 0 11 0x8>, /* Logical - DevToMem */
+			       <&dma 0 11 0x4>; /* Logical - MemToDev */
+			dma-names = "rx", "tx";
+
 			status = "disabled";
 		};
 
-- 
1.7.10.4