[PATCHv2] ARM:dts:omap4-panda:Update the LED support for the panda DTS

[Vincent Stehlé]

On 04/17/2013 10:16 PM, Dan Murphy wrote:
> The GPIO for LED D1 on the omap4-panda a1-a3 rev and the omap4-panda-es
> are different.
(..)
> diff --git a/arch/arm/boot/dts/omap4-panda-common.dtsi b/arch/arm/boot/dts/omap4-panda-common.dtsi
> index 03bd60d..0c48f6b 100644
> --- a/arch/arm/boot/dts/omap4-panda-common.dtsi
> +++ b/arch/arm/boot/dts/omap4-panda-common.dtsi
(..)
> @@ -135,6 +136,25 @@
>  			0xf0 0x118     /* i2c4_sda PULLUP | INPUTENABLE | MODE0 */
>  		>;
>  	};
> +
> +	led_gpio_pins: pinmux_leds_pins {
> +		pinctrl-single,pins = <
> +		>;
> +	};
> +};

Hi,

FYI, there was a recent discussion precisely on this topic, where Tomy
suggested to remove the empty section:
http://marc.info/?l=linux-omap&m=136546635409232&w=2

Apart from that, I just tested your patch on top of Tomy's
omap-for-v3.10/dt branch and it is working fine for me on PandaBoards
EA3, A4 and ES.

Tested-by: Vincent Stehlé <v-stehle at ti.com>

Best regards,

V.