[PATCH v6 3/8] reset: Add driver for gpio-controlled reset pins

[Olof Johansson]

On Thu, Apr 11, 2013 at 8:54 AM, Stephen Warren <swarren at wwwdotorg.org> wrote:
> On 04/11/2013 04:35 AM, Olof Johansson wrote:
>> On Thu, Mar 28, 2013 at 9:35 AM, Philipp Zabel <p.zabel at pengutronix.de> wrote:
>>> This driver implements a reset controller device that toggles gpios
>>> connected to reset pins of peripheral ICs. The delay between assertion
>>> and de-assertion of the reset signal can be configured.
> ...
>> Since this is a platform driver and not just an OF driver, shouldn't
>> you provide a way to specify the same configuration data through a
>> platform_data structure as well?
>
> I believe the only practical use-cases for this driver are /currently/
> for device-tree platforms. Shouldn't we add the platform_data support
> only when some platform actively uses it?

Then the Kconfig needs to depend on OF in this case.

> In the past when reviewing new drivers, I pushed for platform drivers to
> always implement the platform_data structure up-front, and support using
> that if present rather than "falling back" to DT. However, Grant then
> shot that down saying that there was no point adding dead code...

Uh, ok. I don't care much either way but it somehow seems like it'll
be impopular to start adding a lot of new "depends on OF" drivers. I
might be wrong though.

> (this will also feed into the discussion about simple-framebuffer, which
> also only needs DT support right now, but could in theory be extended to
> support platform_data in the future if somebody wants).

Yeah, that's turning out to be a color preference discussion for
sheds, not very surprising.


-Olof