[PATCH v4 00/21] ARM: OMAP2+: Adapt to ehci-omap changes for 3.10

[Tony Lindgren]

* Benoit Cousson <b-cousson at ti.com> [130408 05:11]:
> Hi Tony,
> 
> On 04/05/2013 05:43 PM, Tony Lindgren wrote:
> > * Benoit Cousson <b-cousson at ti.com> [130405 03:00]:
> >> On 04/05/2013 10:30 AM, Benoit Cousson wrote:
> >>
> >> ...
> >>
> >>>>   ARM: dts: OMAP4: Add HS USB Host IP nodes
> >>>>   ARM: dts: OMAP3: Add HS USB Host IP nodes
> >>>>   ARM: dts: omap3-beagle: Add USB Host support
> >>>
> >>> These 3 DTS patches are good to me, but I cannot applied them on top of
> >>> the already existing patches I queued for 3.10.
> >>>
> >>> git://git.kernel.org/pub/scm/linux/kernel/git/bcousson/linux-omap-dt.git
> >>> for_3.10/dts
> >>>
> >>> Could you rebase these 3 ones only, and I will applied them.
> >>
> >> Mmm, in fact, I've just seen the pull request from Tony :-(
> >>
> >>
> >> Tony,
> >>
> >> Don't you want to remove these DTS patches from the pull-request?
> > 
> > Oops sorry :( Looks like I applied them mistakenly as I saved all
> > the patches into a mbox, then applied it. Anyways, too late to start
> > messing with it now.
> >  
> >> Otherwise, I will have to rebase the whole DTS series on top of yours.
> >> That being said, if the branch is not supposed to be rebased, it is doable.
> > 
> > I pulled in your for_3.10/dts for testing, and to me it looks like
> > it's just overlapping additions. So that should be OK to resolve while
> > pulling it in.
> > 
> > It seems there's no need to add omap-for-v3.10/usb as a dependency for
> > your for_3.10/dts unless the conflict gets non-trivial with some
> > additional patches.
> 
> The branch was not complete, with the latest additions, we do have
> conflict due to the addition of several new nodes at the same place.

OK
 
> The resolution is not that hard since it is addition of node only, but
> the rebase on to of omap-for-v3.10/usb will avoid the issue.
> 
> I have a new pre-merged branch available. for_3.10/dts_merged is based
> on omap-for-v3.10/usb and Paul's omap-devel-b-for-3.10 branch to get the
> AM33xx hwmod.
> Paul's branch is just needed to avoid AM33xx regression introduced by
> Santosh hwmod changes present in my branch.
> 
> Just let me know which one you will prefer to pull.

If the merge conflicts are non-trivial, then let's do the pre-merged
branch. That will be easier to test also in this case for am33xx.

Regards,

Tony