[RFC PATCH] CLK: Allow parent clock and rate to be configured in DT.

[Fabio Estevam]

On Sun, Apr 7, 2013 at 12:50 PM, Matt Sealey <matt at genesi-usa.com> wrote:

> If we're dealing with audio codecs, fix the audio codec to accept a
> *table* of possible clock values and if that hardware operates
> differently per clock value, then add that data in there too (like the
> cs42l52 audio codec). Where the software and hardware is a little more
> dynamic, the same binding works here - and the usual trick is just
> force one configuration possible out of many. The board designer can
> look at all the possibilities and choose the one or two or all that
> will work with the design, and it can go into the device tree.

Sorry, but I have a hard time following a so long response.

Can't you just send patches to the list with your proposal so that we
can move forward with the idea?