[PATCH 1/2] ARM: shmobile: bockw: add SMSC ethernet support

[Simon Horman]

From: Kuninori Morimoto <kuninori.morimoto.gx at renesas.com>

This patch adds SMSC ethernet support on Bock-W

Bock-W SMSC needs FPGA settings which enables interrupt.
This patch does it on bockw_init() function.
As notes for future, this FPGA settings should be updated,
since this FPGA is using cascaded interrupt.
Current code is assuming that this FPGA interrupt user is only SMSC.

Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx at renesas.com>
Acked-by: Magnus Damm <damm at opensource.se>
Signed-off-by: Simon Horman <horms+renesas at verge.net.au>
---
 arch/arm/mach-shmobile/Kconfig       |    1 +
 arch/arm/mach-shmobile/board-bockw.c |   38 ++++++++++++++++++++++++++++++++++
 2 files changed, 39 insertions(+)

diff --git a/arch/arm/mach-shmobile/Kconfig b/arch/arm/mach-shmobile/Kconfig
index 549e059..1a517e2 100644
--- a/arch/arm/mach-shmobile/Kconfig
+++ b/arch/arm/mach-shmobile/Kconfig
@@ -133,6 +133,7 @@ config MACH_BOCKW
 	bool "BOCK-W platform"
 	depends on ARCH_R8A7778
 	select ARCH_REQUIRE_GPIOLIB
+	select RENESAS_INTC_IRQPIN
 	select USE_OF
 
 config MACH_MARZEN
diff --git a/arch/arm/mach-shmobile/board-bockw.c b/arch/arm/mach-shmobile/board-bockw.c
index 56ab56e..38e5e50 100644
--- a/arch/arm/mach-shmobile/board-bockw.c
+++ b/arch/arm/mach-shmobile/board-bockw.c
@@ -19,14 +19,52 @@
  */
 
 #include <linux/platform_device.h>
+#include <linux/smsc911x.h>
 #include <mach/common.h>
+#include <mach/irqs.h>
 #include <mach/r8a7778.h>
 #include <asm/mach/arch.h>
 
+static struct smsc911x_platform_config smsc911x_data = {
+	.irq_polarity	= SMSC911X_IRQ_POLARITY_ACTIVE_LOW,
+	.irq_type	= SMSC911X_IRQ_TYPE_PUSH_PULL,
+	.flags		= SMSC911X_USE_32BIT,
+	.phy_interface	= PHY_INTERFACE_MODE_MII,
+};
+
+static struct resource smsc911x_resources[] = {
+	DEFINE_RES_MEM(0x18300000, 0x1000),
+	DEFINE_RES_IRQ(irq_pin(0)), /* IRQ 0 */
+};
+
+#define IRQ0MR	0x30
 static void __init bockw_init(void)
 {
+	void __iomem *fpga;
+
 	r8a7778_clock_init();
+	r8a7778_init_irq_extpin(1);
 	r8a7778_add_standard_devices();
+
+	fpga = ioremap_nocache(0x18200000, SZ_1M);
+	if (fpga) {
+		/*
+		 * CAUTION
+		 *
+		 * IRQ0/1 is cascaded interrupt from FPGA.
+		 * it should be cared in the future
+		 * Now, it is assuming IRQ0 was used only from SMSC.
+		 */
+		u16 val = ioread16(fpga + IRQ0MR);
+		val &= ~(1 << 4); /* enable SMSC911x */
+		iowrite16(val, fpga + IRQ0MR);
+		iounmap(fpga);
+
+		platform_device_register_resndata(
+			&platform_bus, "smsc911x", -1,
+			smsc911x_resources, ARRAY_SIZE(smsc911x_resources),
+			&smsc911x_data, sizeof(smsc911x_data));
+	}
 }
 
 static const char *bockw_boards_compat_dt[] __initdata = {
-- 
1.7.10.4