[PATCH 5/5 v2] ARM: dove: add gigabit device tree nodes to dove.dtsi

[Florian Fainelli]

This patch adds the gigabit ethernet device tree nodes to dove.dtsi in a
disabled state. The gigabit ethernet device tree node must be enabled on
a per-board basis. For completeness and easier testing the MDIO node is
also added in a disabled state.

Signed-off-by: Florian Fainelli <florian at openwrt.org>
---
Changes since v1:
- fixed off-by 0x2000 address of the ethernet-group node

 arch/arm/boot/dts/dove.dtsi |   25 +++++++++++++++++++++++++
 1 file changed, 25 insertions(+)

diff --git a/arch/arm/boot/dts/dove.dtsi b/arch/arm/boot/dts/dove.dtsi
index f7509ca..51de5f7 100644
--- a/arch/arm/boot/dts/dove.dtsi
+++ b/arch/arm/boot/dts/dove.dtsi
@@ -253,5 +253,30 @@
 				dmacap,xor;
 			};
 		};
+
+		mdio at 72004 {
+			#address-cells = <1>;
+			#size-cells = <0>;
+			compatible = "marvell,orion-mdio";
+			reg = <0x72004 0x84>;
+			status = "disabled";
+		};
+
+		ethernet-group at 72000 {
+			#address-cells = <1>;
+			#size-cells = <0>;
+			compatible = "marvell,mv643xx-eth-block";
+			reg = <0x72000 0x4000>;
+			tx-csum-limit = <1600>;
+			status = "disabled";
+
+			egiga0: ethernet at 0 {
+				device_type = "network";
+				compatible = "marvell,mv643xx-eth";
+				reg = <0>;
+				interrupts = <29>;
+				clocks = <&gate_clk 2>;
+			};
+		};
 	};
 };
-- 
1.7.10.4