[PATCH v3 1/2] irqchip: intc-irqpin: Add support for shared interrupt lines

[Simon Horman]

On Wed, Mar 27, 2013 at 02:50:05PM +0100, Bastian Hecht wrote:
> Hi Simon,
> 
> 2013/3/27 Simon Horman <horms at verge.net.au>:
> > On Tue, Mar 26, 2013 at 12:18:18PM +0100, Bastian Hecht wrote:
> >> On some hardware we don't have a 1-1 mapping from the external
> >> interrupts coming from INTC to the GIC SPI pins. We can however
> >> share lines to demux incoming IRQs on these SoCs.
> >>
> >> This patch enables the intc_irqpin driver to detect requests for shared
> >> interrupt lines and demuxes them properly by querying the INTC INTREQx0A
> >> registers.
> >>
> >> If you need multiple shared intc_irqpin device instances, be sure to mask
> >> out all interrupts on the INTC that share the one line before you start
> >> to register them. Else you run into IRQ floods that would be caused by
> >> interrupts for which no handler has been set up yet when the first
> >> intc_irqpin device is registered.
> >>
> >> Signed-off-by: Bastian Hecht <hechtb+renesas at gmail.com>
> >> Acked-by: Magnus Damm <damm at opensource.se>
> >
> > Thanks, I will see about queuing up these changes for v3.10.
> >
> >
> > I believe that with these changes it should be possible to rebase/rework
> > armadillo800eva-reference so that it no longer uses the unmerged INTC
> > DT bindings. Would it be possible for you to see about making a fresh
> > version of armadillo800eva-reference that is based on the next branch
> > in the Renesas tree plus this series of two patches?
> 
> yes ok, I'll prepare a new armadillo reference version. The patches
> were based on all+next, but I'll post a v4 rebased on next.
> I'll post a separate patch series for the reference code if you don't
> mind, as this might take a few days to be done.

Hi Bastian,

gentle nudge with regards to a fresh armadillo-reference.