[PATCH 2/2 V3] MXS: Implement DMA support into mxs-i2c
w.sang at pengutronix.de
Mon Jul 16 06:21:51 EDT 2012
> > I am also still interested to check the runtime switching, but it might
> > take another month until I can really hack on it.
> Good, there is some bit that probably needs to be flipped to allow this
> switching. I managed to get this working with SPI, not with i2c though. With
Ah, hearing that it works with SPI is good news.
> i2c, if I restarted the controller inbetween each transaction, it worked ...
> which is not what I'd like to see there.
> > > No, it doesn't. See above about small transfers. Consider the easy
> > > situation where you have sensor on one bus (so you do PIO because you
> > > transfer small data) and you have EEPROM on other bus, where you use DMA
> > > because you transfer large data. And the mixed mode isn't there yet.
> > I fully understand what you want to configure. I did before. Yet,
> > devicetree bindings are not platform_data and shouldn't be used like
> > them.
> But then, how would you configure this detail on a per-bus basis? Well all
This is a question for devicetree-discuss.
> patch actually fixes a real issue, I'd like to have it in ASAP and it's been
> aboue three months already, which sucks.
I am open to ideas improving the situation (which is: a lot more
patches, but not a lot more reviewers)
Pengutronix e.K. | Wolfram Sang |
Industrial Linux Solutions | http://www.pengutronix.de/ |
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 198 bytes
Desc: Digital signature
More information about the linux-arm-kernel