Device tree binding for DVFS table

[Prashant Gaikwad]

On Wednesday 11 July 2012 07:19 PM, Peter De Schrijver wrote:
> On Wed, Jul 11, 2012 at 03:08:14PM +0200, 함명주 wrote:
>>> Hi,
>>>
>>> I am working on DT binding for Tegra DVFS.
>>>
>>> For Tegra, DVFS node mainly consists of frequency and voltage pairs.
>>> Frequency in the pair may change for different process. E.g. for process
>>> 1 CPU clock frequency could be 900MHz at 1V while for process 2 it could
>>> be 1GHz at 1V.
>>> Tegra uses vendor specific ids to identify the correct frequency table.
>> Hello,
>>
>> It seems that in the example, the values in "voltage-array" and
>> "frequencies" are switched.
>>
>> Anyway, what about SoCs that reads information from IEM (or any other module)
>>   to measure gate delays or some other value to set the appriorate voltage values
>>   for every possible frequency? I remember some of Exynos SoCs have been doing
>>   it; dynamically measure the characteristics at boot-up time and apply voltages
>>   accordingly; they couldn't identify it based on the chip-id or simply by reading
>>   a single register.
>>
>
> But in that case you would have a nominal voltage for each OPP which gets
> adjusted at boottime or runtime depending on the exact silicon characteristics?
> I would say the DT binding should then specify 1 table with the nominal values
> and leave the dynamics to the driver.

It makes sense or is it different than this?

> Cheers,
>
> Peter.
>