[PATCH v5 3/3] ARM: OMAP2+: onenand: prepare for gpmc driver migration

Tony Lindgren tony at atomide.com
Tue Jul 10 09:17:34 EDT 2012


* Mohammed, Afzal <afzal at ti.com> [120710 03:09]:
> Hi Tony,
> 
> On Tue, Jul 10, 2012 at 15:15:38, Tony Lindgren wrote:
> > * Mohammed, Afzal <afzal at ti.com> [120709 23:24]:
> > > On Fri, Jul 06, 2012 at 17:35:33, Tony Lindgren wrote:
> 
> > > > format. But the peripheral specific retime function still needs to be
> > > > also registered for peripherals that need it.
> > > 
> > > For the peripherals requiring retime, we cannot (as otherwise whatever
> > > retime does would have to be manually done based on the knowledge of
> > > boot time gpmc clock period to calculate gpmc timings to be fed to DT)
> > > pass gpmc timings via device tree, right ?
> > 
> > We can still do it when the connected peripheral probe registers with
> > gpmc.
> 
> We can, but would it be feasible practically ?, gpmc timings to update in
> DT for a such a peripheral (requiring retime) can be found out only by
> manual calculation similar to the way done in retime function (based on
> peripheral's timings and boot time gpmc clock period), correct ?, Also
> wouldn't this make it necessary to know gpmc clock period at boot time
> for properly updating gpmc timing entry in DT ?

The gpmc clock period can be returned to the connected peripheral when
it's registering. Well basically we can call the retime function upon
registering and pass the gpmc clock period.
 
> And in this case, we are going to register retime function, so instead of
> relying on DT to provide gpmc timings for such a peripheral, won't it
> be better to make use of retime that is already registered ?

No we need to pass the timings from device tree as they may be different
for similar boards. For example, different level shifters used on
similar boards may affect the timings, although the retime function
can be the same.

Regards,

Tony



More information about the linux-arm-kernel mailing list