[PATCH v1 07/11] drivers: usb: twl4030: Add device tree support for twl4030 usb

Rajendra Nayak rnayak at ti.com
Tue Jul 10 03:02:17 EDT 2012


On Tuesday 10 July 2012 12:22 PM, ABRAHAM, KISHON VIJAY wrote:
>>> +TWL4030 USB PHY AND COMPARATOR
>>> >>  + - compatible : Should be "ti,twl4030-usb"
>>> >>  + - interrupts : The interrupt numbers to the cpu should be specified.
>>> >>  First
>>> >>  +   interrupt number is the otg interrupt number that raises ID interrupts
>>> >>  +   and VBUS interrupts. The second interrupt number is optional.
>>> >>  + -<supply-name>-supply : phandle to the regulator device tree node.
>>> >>  +<supply-name>   should be vusb1v5, vusb1v8 and vusb3v1
>>> >>  + - usb_mode : The mode used by the phy to connect to the controller. "1"
>>> >>  +   specifies "ULPI" mode and "2" specifies "CEA2011_3PIN" mode.
>> >
>> >
>> >  Are these standard usb phy modes or something specific to the twl4030
>> >  usb phy?
> These are standard modes used to connect the phy to the controller. I
> think it's used by other chips other than twl4030 (Something in
> am35xx??).

So would it make sense to document these bindings independent of a given
phy and a given controller, so it could be reused and not duplicated in
various forms for various different controllers.



More information about the linux-arm-kernel mailing list