[PATCH] gpio/omap: fix invalid context restore of gpio bank-0

[Jon Hunter]

On 07/02/2012 01:07 PM, Kevin Hilman wrote:
> + Neil Brown
> 
> Hi Jon,
> 
> Jon Hunter <jon-hunter at ti.com> writes:
> 
>> Currently the gpio _runtime_resume/suspend functions are calling the
>> get_context_loss_count() platform function if the function is populated for
>> a gpio bank. This function is used to determine if the gpio bank logic state
>> needs to be restored due to a power transition. This function will be populated
>> for all banks, but it should only be called for banks that have the
>> "loses_context" variable set. It is pointless to call this if loses_context is
>> false as we know the context will never be lost and will not need restoring.
>>
>> For all OMAP2+ devices gpio bank-0 is in an always-on power domain and so will
>> never lose context. We found that the get_context_loss_count() was being called
>> for bank-0 during the probe and returning 1 instead of 0 indicating that the
>> context had been lost. This was causing the context restore function to be
>> called at probe time for this bank and because the context had never been saved,
>> was restoring an invalid state. This ultimately resulted in a crash [1].
>>
>> There are multiple bugs here that need to be addressed ...
>>
>> 1. Why the always-on power domain returns a context loss count of 1? This needs
>>    to be fixed in the power domain code. However, the gpio driver should not
>>    assume the loss count is 0 to begin with.
>> 2. The omap gpio driver should never be calling get_context_loss_count for a
>>    gpio bank in a always-on domain. This is pointless and adds unneccessary
>>    overhead.
>> 3. The OMAP gpio driver assumes that the initial power domain context loss count
>>    will be 0 at the time the gpio driver is probed. However, it could be
>>    possible that this is not the case and an invalid context restore could be
>>    performed during the probe. To avoid this otherwise only populated the
> 
> The 'To avoid this...' sentence here doesn't read well.  Looks like you
> need to:
> 
> s/otherwise//

Yes, I meant to have dropped "otherwise" here. Thanks!

> s/populated/populate/

Yes that too! I must have re-worded and screwed it up royally :-(

> ?
> 
>>    get_context_loss_count() function pointer after the initial call to
>>    pm_runtime_get() has occurred. This will ensure that the first
>>    pm_runtime_put() initialised the loss count correctly.
>>
>> This patch addresses issues 2 and 3 above.
>> [1] http://marc.info/?l=linux-omap&m=134065775323775&w=2
>>
>> Cc: Grant Likely <grant.likely at secretlab.ca>
>> Cc: Linus Walleij <linus.walleij at stericsson.com>
>> Cc: Kevin Hilman <khilman at ti.com>
>> Cc: Tarun Kanti DebBarma <tarun.kanti at ti.com>
>> Cc: Franky Lin <frankyl at broadcom.com>
>>
>> Reported-by: Franky Lin <frankyl at broadcom.com>
>> Signed-off-by: Jon Hunter <jon-hunter at ti.com>
> 
> Thanks for digging inot this bug Jon.  The same bug was brought up by
> Neil Brown (Cc'd) in a different thread.
> 
> Neil, it looks to me that this fix will address the problems you were
> seeing as well.  Care to test, and respond with your ack/tested-by if it
> works for you?  Thanks.

Neil let me know your thoughts and if you are ok, I can clean-up the
changelog and re-send.

Cheers
Jon