[PATCH v2 0/2] patch set about the MXS-DMA
Huang Shijie
b32955 at freescale.com
Tue Jan 31 21:21:35 EST 2012
hi,
> patch 1: move the mxs dma header to a more common place.
> Beside the mx23/mx28, the apbh-dma is also used by MX50 and MX6Q.
> So move the mxs dma header file to a more common place, and rename
> it to mxs-dma.h
>
> patch 2: rewrite the last parameter of mxs_dma_prep_slave_sg().
> In the new GPMI version, some hardware behavior changes.
> The WAIT4END bit should be set in the middle one of the ECC READ page DMA chain.
> The DMA chain should be set like this:
>
> +-----+ +-----+ +-----+
> | cmd | ------------> | cmd | ------------------> | cmd |
> +-----+ +-----+ +-----+
> ^ ^
> | |
> | |
> set WAIT4END here too set WAIT4END here
>
> So rewrite the last parameter of mxs_dma_prep_slave_sg(), use the
> dma_ctrl_flags to set the proper DMA bit for DMA Command Structure.
> And change the relative drivers with the dma_ctrl_flags.
>
> TEST:
> Tested the mxs-mmc driver and gpmi-nand drive with the two patches
> in MX28 board.
>
> v1 --> v2:
> [1] squash the trial patches into single patch.
> [2] use the dma_ctrl_flags.
>
> Huang Shijie (2):
> mxs-dma : move the mxs dma.h to a more common place
> mxs-dma : rewrite the last parameter of mxs_dma_prep_slave_sg()
>
> drivers/dma/mxs-dma.c | 34 +++++++++++++++++---
> drivers/mmc/host/mxs-mmc.c | 12 +++---
> drivers/mtd/nand/gpmi-nand/gpmi-lib.c | 28 +++++++++++++---
> drivers/mtd/nand/gpmi-nand/gpmi-nand.h | 6 +++-
> drivers/mtd/nand/gpmi-nand/gpmi-regs.h | 2 +
> .../include/mach/dma.h => include/linux/mxs-dma.h | 0
> sound/soc/mxs/mxs-pcm.c | 2 +-
> sound/soc/mxs/mxs-pcm.h | 2 +-
> sound/soc/mxs/mxs-saif.c | 2 +-
> 9 files changed, 67 insertions(+), 21 deletions(-)
> rename arch/arm/mach-mxs/include/mach/dma.h => include/linux/mxs-dma.h (100%)
>
ping.
Could these two patches ok ?
My following patches depend upon them.
BR
Huang Shijie
More information about the linux-arm-kernel
mailing list