[PATCH v3 14/25] irq_domain: Remove irq_domain_add_simple()

Grant Likely grant.likely at secretlab.ca
Tue Jan 31 19:08:48 EST 2012


On Tue, Jan 31, 2012 at 09:58:22PM +0800, Shawn Guo wrote:
> On Tue, Jan 31, 2012 at 07:15:26AM -0600, Rob Herring wrote:
> ...
> > >> --- a/arch/arm/mach-mx5/imx51-dt.c
> > >> +++ b/arch/arm/mach-mx5/imx51-dt.c
> > >> @@ -47,7 +47,7 @@ static const struct of_dev_auxdata imx51_auxdata_lookup[] __initconst = {
> > >>  static int __init imx51_tzic_add_irq_domain(struct device_node *np,
> > >>  				struct device_node *interrupt_parent)
> > >>  {
> > >> -	irq_domain_add_simple(np, 0);
> > >> +	irq_domain_add_legacy(np, 32, 0, 0, &irq_domain_simple_ops, NULL);
> > >>  	return 0;
> > >>  }
> > >>  
> > >> @@ -57,7 +57,7 @@ static int __init imx51_gpio_add_irq_domain(struct device_node *np,
> > >>  	static int gpio_irq_base = MXC_GPIO_IRQ_START + ARCH_NR_GPIOS;
> > >>  
> > >>  	gpio_irq_base -= 32;
> > >> -	irq_domain_add_simple(np, gpio_irq_base);
> > >> +	irq_domain_add_legacy(np, 32, gpio_irq_base, 0, &irq_domain_simple_ops, NULL);
> > > 
> > > The tzic on imx5 gets 128 irq lines rather than 32 here.  The current
> > > code will make any hwirq that is > 32 hit the WARN_ON below in
> > > irq_domain_legacy_revmap().
> > 
> > But this is the gpio controller code? Really this should be 4 domains,
> > but this temp fix is probably fine until you use my generic irq chip
> > support.
> > 
> Sorry.  The comment was put at the wrong place.  It should be against
> imx51_tzic_add_irq_domain() just above.

I didn't know how large the bank was, so I just assumed 32.  If it should
be 128 then I'll change it.  Please confirm (or reply with a fixup patch)

g.




More information about the linux-arm-kernel mailing list