[PATCH] ARM: S3C64XX: Use IN4 DC measurement mode on Tobermory

[Kukjin Kim]

Mark Brown wrote:
> 
> The WM8962 on Tobermory has one of the IN4 inputs connected for DC
> measurement. Tell the driver it can optimise for this mode.
> 
> Signed-off-by: Mark Brown <broonie at opensource.wolfsonmicro.com>
> ---
> 
> This feature is going to be merged via ASoC in 3.4 - is it OK if I apply
> this patch to the ASoC tree too?  It's a one liner, I'd be astonished if
> it were to generate any conflicts.
> 
Yes, would be better. If required, please go ahead with my ack:
Acked-by: Kukjin Kim <kgene.kim at samsung.com>

Thanks.

Best regards,
Kgene.
--
Kukjin Kim <kgene.kim at samsung.com>, Senior Engineer,
SW Solution Development Team, Samsung Electronics Co., Ltd.

>  arch/arm/mach-s3c64xx/mach-crag6410-module.c |    1 +
>  1 files changed, 1 insertions(+), 0 deletions(-)
> 
> diff --git a/arch/arm/mach-s3c64xx/mach-crag6410-module.c b/arch/arm/mach-
> s3c64xx/mach-crag6410-module.c
> index 509307d..317f866 100644
> --- a/arch/arm/mach-s3c64xx/mach-crag6410-module.c
> +++ b/arch/arm/mach-s3c64xx/mach-crag6410-module.c
> @@ -128,6 +128,7 @@ static struct wm8962_pdata wm8962_pdata __initdata = {
>  		0x8000 | WM8962_GPIO_FN_DMICDAT,
>  		WM8962_GPIO_FN_IRQ,    /* Open drain mode */
>  	},
> +	.in4_dc_measure = true,
>  };
> 
>  static struct wm9081_pdata wm9081_pdata __initdata = {
> --
> 1.7.9.rc1