[RFC PATCH 4/7] ARM: davinci: net: davinci_emac: add OF support
Heiko Schocher
hs at denx.de
Mon Jan 23 03:56:04 EST 2012
add of support for the davinci_emac driver.
Signed-off-by: Heiko Schocher <hs at denx.de>
Cc: davinci-linux-open-source at linux.davincidsp.com
Cc: linux-arm-kernel at lists.infradead.org
Cc: devicetree-discuss at lists.ozlabs.org
Cc: netdev at vger.kernel.org
Cc: Grant Likely <grant.likely at secretlab.ca>
Cc: Sekhar Nori <nsekhar at ti.com>
Cc: Wolfgang Denk <wd at denx.de>
---
.../bindings/arm/davinci/davinci_emac.txt | 46 ++++++++
drivers/net/ethernet/ti/davinci_emac.c | 111 +++++++++++++++++++-
2 files changed, 156 insertions(+), 1 deletions(-)
create mode 100644 Documentation/devicetree/bindings/arm/davinci/davinci_emac.txt
diff --git a/Documentation/devicetree/bindings/arm/davinci/davinci_emac.txt b/Documentation/devicetree/bindings/arm/davinci/davinci_emac.txt
new file mode 100644
index 0000000..4e5dc8d
--- /dev/null
+++ b/Documentation/devicetree/bindings/arm/davinci/davinci_emac.txt
@@ -0,0 +1,46 @@
+* Texas Instruments Davinci EMAC
+
+This file provides information, what the davice node
+for the davinci_emac interface contain.
+
+Required properties:
+- compatible: "ti,davinci-emac";
+- reg: Offset and length of the register set for the device
+- ctrl_reg_offset: offset to control register
+- ctrl_mod_reg_offset: offset to control module register
+- ctrl_ram_offset: offset to control module ram
+- hw_ram_addr: hardware ram addr
+- ctrl_ram_size: size of control module ram
+- version: 1 (EMAC_VERSION_1 for DM644x)
+ 2 (EMAC_VERSION_2 for DM646x)
+- phy-handle: Contains a phandle to an Ethernet PHY.
+ if not, davinci_emac driver defaults to 100/FULL
+- interrupts: interrupt mapping for the davinci emac interrupts sources:
+ 4 sources: <Receive Threshold Interrupt
+ Receive Interrupt
+ Transmit Interrupt
+ Miscellaneous Interrupt>
+- pinmux-handle: Contains a handle to configure the pinmux settings.
+
+Optional properties:
+- local-mac-address : 6 bytes, mac address
+
+Example (enbw_cmc board):
+ eth0: emac at 1e20000 {
+ compatible = "ti,davinci-emac";
+ reg = <0x220000 0x4000>;
+ ctrl_reg_offset = <0x3000>;
+ ctrl_mod_reg_offset = <0x2000>;
+ ctrl_ram_offset = <0>;
+ hw_ram_addr = <0>;
+ ctrl_ram_size = <0x2000>;
+ version = <1>;
+ local-mac-address = [ 00 00 00 00 00 00 ];
+ interrupts = <33
+ 34
+ 35
+ 36
+ >;
+ interrupt-parent = <&intc>;
+ pinmux-handle = <&emac_pins>;
+ };
diff --git a/drivers/net/ethernet/ti/davinci_emac.c b/drivers/net/ethernet/ti/davinci_emac.c
index 794ac30..cad7a96 100644
--- a/drivers/net/ethernet/ti/davinci_emac.c
+++ b/drivers/net/ethernet/ti/davinci_emac.c
@@ -58,6 +58,12 @@
#include <linux/io.h>
#include <linux/uaccess.h>
#include <linux/davinci_emac.h>
+#include <linux/of.h>
+#include <linux/of_address.h>
+#include <linux/of_irq.h>
+#include <linux/of_net.h>
+
+#include <mach/mux.h>
#include <asm/irq.h>
#include <asm/page.h>
@@ -339,6 +345,9 @@ struct emac_priv {
u32 rx_addr_type;
atomic_t cur_tx;
const char *phy_id;
+#ifdef CONFIG_OF
+ struct device_node *phy_node;
+#endif
struct phy_device *phydev;
spinlock_t lock;
/*platform specific members*/
@@ -1582,6 +1591,7 @@ static int emac_dev_open(struct net_device *ndev)
cpdma_ctlr_start(priv->dma);
priv->phydev = NULL;
+
/* use the first phy on the bus if pdata did not give us a phy id */
if (!priv->phy_id) {
struct device *phy;
@@ -1759,6 +1769,104 @@ static const struct net_device_ops emac_netdev_ops = {
#endif
};
+#ifdef CONFIG_OF
+static struct emac_platform_data
+ *davinci_emac_of_get_pdata(struct platform_device *pdev,
+ struct emac_priv *priv)
+{
+ struct device_node *np;
+ struct device_node *pinmux_np;
+ struct emac_platform_data *pdata = NULL;
+ const u8 *mac_addr;
+ u32 data;
+ int ret;
+ struct resource temp_res;
+ int irq;
+ int index = 0;
+
+ np = of_find_compatible_node(NULL, NULL, "ti,davinci-emac");
+ if (!np)
+ goto nodata;
+
+ pdata = pdev->dev.platform_data;
+ if (!pdata) {
+ pdata = kzalloc(sizeof(struct emac_platform_data), GFP_KERNEL);
+ if (!pdata)
+ goto nodata;
+ }
+
+ mac_addr = of_get_mac_address(np);
+ if (mac_addr)
+ memcpy(pdata->mac_addr, mac_addr, ETH_ALEN);
+
+ ret = of_property_read_u32(np, "ctrl_reg_offset", &data);
+ if (!ret)
+ pdata->ctrl_reg_offset = data;
+
+ ret = of_property_read_u32(np, "ctrl_mod_reg_offset", &data);
+ if (!ret)
+ pdata->ctrl_mod_reg_offset = data;
+
+ ret = of_property_read_u32(np, "ctrl_ram_offset", &data);
+ if (!ret)
+ pdata->ctrl_ram_offset = data;
+
+ ret = of_property_read_u32(np, "hw_ram_addr", &data);
+ if (!ret)
+ pdata->hw_ram_addr = data;
+
+ ret = of_property_read_u32(np, "ctrl_ram_size", &data);
+ if (!ret)
+ pdata->ctrl_ram_size = data;
+
+ ret = of_property_read_u32(np, "rmii_en", &data);
+ if (!ret)
+ pdata->rmii_en = data;
+
+ ret = of_property_read_u32(np, "version", &data);
+ if (!ret)
+ pdata->version = data;
+
+ ret = of_property_read_u32(np, "no_bd_ram", &data);
+ if (!ret)
+ pdata->ctrl_mod_reg_offset = data;
+
+ priv->phy_node = of_parse_phandle(np, "phy-handle", 0);
+ if (!priv->phy_node)
+ pdata->phy_id = "";
+
+ if (!of_address_to_resource(np, 0, &temp_res))
+ memcpy(&pdev->resource[0], &temp_res, sizeof(struct resource));
+
+ index = 0;
+ while (index < 4) {
+ irq = irq_of_parse_and_map(np, index);
+ if (irq > 0) {
+ temp_res.start = irq;
+ temp_res.end = irq;
+ temp_res.flags = IORESOURCE_IRQ;
+ memcpy(&pdev->resource[index + 1], &temp_res,
+ sizeof(struct resource));
+ }
+ index++;
+ }
+
+ pinmux_np = of_parse_phandle(np, "pinmux-handle", 0);
+ if (pinmux_np)
+ davinci_cfg_reg_of(pinmux_np);
+
+ pdev->dev.platform_data = pdata;
+nodata:
+ return pdata;
+}
+#else
+static struct emac_platform_data
+ *davinci_emac_of_get_pdata(struct platform_device *pdev,
+ struct emac_priv *priv)
+{
+ return pdev->dev.platform_data;
+}
+#endif
/**
* davinci_emac_probe: EMAC device probe
* @pdev: The DaVinci EMAC device that we are removing
@@ -1802,7 +1910,7 @@ static int __devinit davinci_emac_probe(struct platform_device *pdev)
spin_lock_init(&priv->lock);
- pdata = pdev->dev.platform_data;
+ pdata = davinci_emac_of_get_pdata(pdev, priv);
if (!pdata) {
dev_err(&pdev->dev, "no platform data\n");
rc = -ENODEV;
@@ -1811,6 +1919,7 @@ static int __devinit davinci_emac_probe(struct platform_device *pdev)
/* MAC addr and PHY mask , RMII enable info from platform_data */
memcpy(priv->mac_addr, pdata->mac_addr, 6);
+
priv->phy_id = pdata->phy_id;
priv->rmii_en = pdata->rmii_en;
priv->version = pdata->version;
--
1.7.7.5
More information about the linux-arm-kernel
mailing list