[PATCH 00/10] patch set about the MXS-DMA

[Shawn Guo]

On Thu, Jan 19, 2012 at 02:15:57PM +0800, Huang Shijie wrote:
> This patch set does two things about the MXS-DMA:
> [1] patch 1 ~ patch 5: move the mxs dma header to a more common place.
> 	Beside the mx23/mx28, the APBH-DMA is also used by MX50 and MX6Q.
> 	So move the mxs dma header file to a more common place, and rename
> 	it to mxs-dma.h
> 
For the sake of bitsec, these 5 patches need to be one.

> [2] patch 6 ~ patch 10: rewrite the last parameter of mxs_dma_prep_slave_sg().

For the sake of bitsec, at least patches #7 and #8 need to be one patch.
That said, if I apply the series and then check out the commit at patch
#7, you need to all mxs-dma client drivers, mxs-mmc, gpmi do not break.

> 	In the new GPMI version, some hardware behavior changes.
> 	The WAIT4END bit should be set in the middle one of the ECC READ page DMA chain.
> 	The DMA chain should be set like this:
> 
>           +-----+               +-----+                      +-----+
>           | cmd | ------------> | cmd | ------------------>  | cmd |
>           +-----+               +-----+                      +-----+
>                                    ^                            ^
>                                    |                            |
>                                    |                            |
>                               set WAIT4END here too        set WAIT4END here
> 
>          Please read the comment in patch "MXS-DMA : add more flags for MXS-DMA".
> 
> Huang Shijie (10):
>   MXS-DMA : move the mxs-dma.h to a more common place
>   MXS-DMA : change the header
>   MXS-MMC : change the DMA header file
>   MTD/GPMI : change the DMA header file
>   ASoc : change the DMA header file
>   MXS-DMA : add more flags for MXS-DMA
>   MXS-DMA : change the last parameter of mxs_dma_prep_slave_sg()
>   MXS-MMC : use the new DMA flags
>   MTD/GPMI : add a new field `gpmi_version`
>   MTD/GPMI : change the code for new DMA interface
> 
Please try to make these subject prefix consistent with the existing
ones in the tree.  You can get them from 'git log' output.  For example
"mxs-dma: ..." is better than "MXS-DMA : ...".

-- 
Regards,
Shawn