[PATCH] video: s3c-fb: Add device tree support

[Jingoo Han]

Hi, Thomas.

> -----Original Message-----
> From: Thomas Abraham [mailto:thomas.abraham at linaro.org]
> Sent: Tuesday, January 10, 2012 5:02 AM
> To: linux-fbdev at vger.kernel.org; devicetree-discuss at lists.ozlabs.org
> Cc: FlorianSchandinat at gmx.de; grant.likely at secretlab.ca; rob.herring at calxeda.com; linux-arm-
> kernel at lists.infradead.org; linux-samsung-soc at vger.kernel.org; kgene.kim at samsung.com;
> jg1.han at samsung.com; patches at linaro.org
> Subject: [PATCH] video: s3c-fb: Add device tree support
> 
> Add device tree based discovery support for Samsung's display controller.
> 
> Cc: Grant Likely <grant.likely at secretlab.ca>
> Cc: Rob Herring <rob.herring at calxeda.com>
> Signed-off-by: Thomas Abraham <thomas.abraham at linaro.org>
> ---
>  .../devicetree/bindings/fb/samsung-fb.txt          |  103 ++++++++++
>  drivers/video/s3c-fb.c                             |  209 +++++++++++++++++++-
>  2 files changed, 304 insertions(+), 8 deletions(-)
>  create mode 100644 Documentation/devicetree/bindings/fb/samsung-fb.txt
> 
> [...]
>
> +- samsung,fimd-bpp: Specifies the bits per pixel. Two values should be
> +  specified in the following order.
> +    - max-bpp: maximum required bpp for the overlay.
> +    - default-bpp: bpp supported by the overlay.
> [...]
> +		fimd-overlay0 {
> +			samsung,fimd-htiming = <64 16 48 1024>;
> +			samsung,fimd-vtiming = <64 16 3 600>;
> +			samsung,fimd-bpp = <24 32>;
> +		};
> +
> +		fimd-overlay1 {
> +			samsung,fimd-htiming = <64 16 48 200>;
> +			samsung,fimd-vtiming = <64 16 3 100>;
> +			samsung,fimd-bpp = <16 32>;
> +		};
> +	};
In the above 'samsung-fb.txt', the order is defined as max-bpp and default-bpp.
However, <24 32> and <16 32> seems to be wrong.
It should be <32 24> and <32 16>, respectively.
Max bpp would be 32bpp in s3c-fb.

Best regards,
Jingoo Han