[PATCH RFC] omap-serial: make serial_omap_restore_context depend on CONFIG_PM_RUNTIME

Shubhrajyoti D shubhrajyoti at ti.com
Wed Jan 11 00:56:40 EST 2012


The function serial_omap_restore_context is called only from
serial_omap_runtime_resume which depends on CONFIG_PM_RUNTIME. Make
serial_omap_restore_context also compile conditionally.

if CONFIG_PM_RUNTIME is not defined below warn may be seen.

  LD      net/xfrm/built-in.o
drivers/tty/serial/omap-serial.c:1524: warning: 'serial_omap_restore_context' defined but not used
  CC      drivers/tty/vt/selection.o

Signed-off-by: Shubhrajyoti D <shubhrajyoti at ti.com>
---
applies on Tony's uart branch

 drivers/tty/serial/omap-serial.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c
index ca24ab3..91b0f65 100644
--- a/drivers/tty/serial/omap-serial.c
+++ b/drivers/tty/serial/omap-serial.c
@@ -1521,6 +1521,7 @@ static void serial_omap_mdr1_errataset(struct uart_omap_port *up, u8 mdr1)
 	}
 }
 
+#ifdef CONFIG_PM_RUNTIME
 static void serial_omap_restore_context(struct uart_omap_port *up)
 {
 	if (up->errata & UART_ERRATA_i202_MDR1_ACCESS)
@@ -1550,7 +1551,6 @@ static void serial_omap_restore_context(struct uart_omap_port *up)
 		serial_out(up, UART_OMAP_MDR1, up->mdr1);
 }
 
-#ifdef CONFIG_PM_RUNTIME
 static int serial_omap_runtime_suspend(struct device *dev)
 {
 	struct uart_omap_port *up = dev_get_drvdata(dev);
-- 
1.7.1




More information about the linux-arm-kernel mailing list