[PATCH 1/3] ATMEL: fix nand ecc support
Artem Bityutskiy
dedekind1 at gmail.com
Tue Jan 10 16:56:54 EST 2012
On Sat, 2012-01-07 at 11:49 +0100, Jean-Christophe PLAGNIOL-VILLARD
wrote:
> +#ifndef __ATMEL_NAND_H__
> +#define __ATMEL_NAND_H__
> +
> +#include <linux/mtd/nand.h>
> +
> + /* NAND / SmartMedia */
> +struct atmel_nand_data {
> + int enable_pin; /* chip enable */
> + int det_pin; /* card detect */
> + int rdy_pin; /* ready/busy */
> + u8 rdy_pin_active_low; /* rdy_pin value is inverted */
> + u8 ale; /* address line number connected to ALE */
> + u8 cle; /* address line number connected to CLE */
> + u8 bus_width_16; /* buswidth is 16 bit */
> + u8 ecc_mode; /* ecc mode */
> + struct mtd_partition *parts;
> + unsigned int num_parts;
> +};
> +
> +#endif /* __ATMEL_NAND_H__ */
The "include/linux" directory, I think, should generally contain only
those headers which define some "userspace-kernel" or "kernel subsystem"
API. This file defines Atmel NAND driver's, so it should not be placed
there.
I am not sure "include/linux" is the best place for this header - is it?
Artem.
More information about the linux-arm-kernel
mailing list