[PATCH] ARM: mach-imx: Kconfig: Do not select Babbage for MACH_IMX51_DT

[Shawn Guo]

On Fri, Dec 28, 2012 at 12:25:47PM -0200, Fabio Estevam wrote:
> From: Fabio Estevam <fabio.estevam at freescale.com>
> 
> When mx51 dt support was added it was necessary to select MACH_MX51_BABBAGE in
> order to get the mx51 dt built without errors.
> 
> At that time, there was no pinctrl support for mx51 yet.
> 
> Currently there is no need to select MACH_MX51_BABBAGE anymore.
> 
> Reported-by: Matt Sealy <matt at genesi-usa.com>
> Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>

Applied, thanks.