[PATCH v6 0/8] pinctrl: support mmp silicon with single driver

[Haojian Zhuang]

Changelog:
v6:
1. Two configuration array will be created for each pin group.
This first array is stored in pcs_function structure. The 32-bit 
configruation argument is stored in this array. Driver stores 
data while parsing DTS file, and loads these config array if 
function selector is indicated.
The second array is stored in pinctrl_map structure. Driver won't
use it directly. So we could avoid to append lookup pinctrl map
method that is introduced in v5.

v5:
1. Move the properties of pinconf into pin group. So those mask
properties could be merged with other pinconf properties.
2. Append lookup pinctrl map method.
3. Append input schmitt disable config parameter.
4. Clean code.

v4:
1. Define gpio range as sub-node, not label. And remove
pinctrl-single,gpio-ranges property.
2. Use new two properties in sub-node, reg &
pinctrl-single,gpio. GPIO number & GPIO function are listed in
the pinctrl-single,gpio property.
3. Reference the names like pinctrl-single,bias.
4. Add compatible name "pinconf-single". If the compatible name is
"pinctrl-single", there's no pinconf. If the compatible name is
"pinconf-single", there's the generic pinconf in pinctrl-single.
5. Update documents.

v3:
1. Add more comments in document.
2. Replace pcs_readl() & pcs_writel() by pcs->read() & pcs->write().
3. Clean code.

v2:
1. Remove "pinctrl-single,gpio-mask". Since GPIO function is one of the
mux function in the pinmux register of both OMAP and PXA/MMP silicons.
Use "pinctrl-single,function-mask" instead.
2. Remove "pinctrl-single,gpio-enable" & "pinctrl-single,gpio-disable".
Use "pinctrl-single,gpio-func" instead. Because GPIO mode is only one
of the mux functions in the pinmux register. Defining "gpio-enable" &
"gpio-disable" are redundant.
3. Define register with __iomem, not u32 type.
4. Remove "pinctrl-single,input-schmit-shift",
"pinctrl-single,power-source-shift", "pinctrl-single,bias-shift". All
these properties could be calculated by mask fields.
5. Return -EPROBE_DEFER if pinmux could be got in device driver. And
the device driver would be probed again deferred.